WAVE6000，南京伟福的最新单片机开发环境

msp430F149 FLL模块程序，很好用-msp430F149 FLL module procedures, good use

采用CYGNAL F015单片机，用于一个电池老化试验柜（即循环充放电）的实用程序，实现了SMBUS总线通信协议。-used CYGNAL macroeconomic microcontroller, for a battery aging test counters (that is, charge-discharge cycle), the practical procedures to achieve the SMBUS bus communication protocols.

8051单片机上4*4矩阵键盘的扫描方式3-none

时钟芯片ds12c887读写程序.rar 小程序,请大家参考参考.

简易智能电动小车程序，寻迹、探测金属、寻光源、避障-Simple smart electric car program, tracing, detection of metal, look for light source, obstacle avoidance

使用protel99软件编辑的原理电路图，希望对各位有助于电路图的学习和开发-The use of the principle of circuit protel99 software editor, in the hope you will help the study and development of circuit

iic工作子程序，用c51编写的我正在使用，献给诸位，改一下就可使用的有其他的需要联系我-work subroutine with c51 I was prepared to use, dedicated to you, change it can be used in any other links to the needs me!

本程序可以支持SLE4442、SLE4428、FALSH、CPU卡-this program can support SLE4442, SLE4428 logic, FALSH, CPU card

1.将P1.0～P1.3接开关，将P1.4～P1.7接发光二极管。依据P1.0～P1.3开关状态控制P1.4~P1.7发光二极管点亮。 2.将P1.0～P1.7全部接发光二极管，开始P1.0、P1.5点亮，左循环50次后P1.1、P1.4点亮；右循环30次，循环往复。-1. P1.0- P1.3 will then switch to P1.4- P1.7 access LEDs. P1.0- P1.3 based on state control switch P1.4- P1.7 LED lights. 2. P1.0- P1.7 will take all LEDs started Schematic, P1.5 lit, the left circle after 50 P1.1 and P1.4 lit; Turn right circle 30 times repeated.

单片机实例，报告，很多的应用实例，对于初级单片机程序员有很大作用-Singlechip example, reports, a lot of application examples for the primary single-chip programmer plays a significant role in