多目标粒子群优化算法在MATLAB中的代码

这是saleh提出其高功率放大器模型的原文 很难找 给大家共享(This is saleh to present its high-power amplifier model of the original hard to find for everyone to share)

完整的qpsk通信系统，包括发送端，接收端，在不同的信道模型下的仿真：awgn，rayleigh。包括各种眼图，星座图，基带波形，载波波形。(Complete the qpsk communication system, including the sender, the receiver in a different channel model Simulation: awgn, and Rayleigh. Including a variety of eye diagram, constellation, waveform baseband carrier waveform.)

模拟退火法求函数的最小值 结束条件为两次最优解之差小于某小量(End condition of the simulated annealing method and function of the minimum of twice the optimal solution of the difference is smaller than some small amount of)

宽带OFDM信号模型的建立，用于宽带OFDM信号的DOA估计，已经用于毕业设计(Wideband OFDM signal model, for broadband OFDM signal DOA estimation, has been used for graduation)

基于人群分类的SEIR模型的仿真，得出模型中各参数(传播率，等)对谣言传播范围的影响(Simulation of SEIR model based on crowd classification)

函数 test_ekf kx =.01; ky =.05; %阻尼系数 g = 9.8; % 重力 t = 10; % 仿真时间 Ts = 0.1; % 采样周期 len = %； fix(t/Ts)仿真步数 % 真实轨迹模拟 dax 指数 = 1.5 ； 天 = 1.5 ；% 系统噪声 X = zeros(len,4);X(1,:) = [0、 50、 500，0]; % 状态模拟的初值 k 2:len = x = X(k-1,1);vx = X(k-1,2) ；y = X(k-1,3) ；vy = X(k-1,4) ； x = x + vx * Ts; vx = vx + (-kx*vx^2+dax*randn(1,1)) * Ts; y = y + vy

朴素贝叶斯matlab实现，基于matlab编程(Naive Bayes matlab to achieve, based on the matlab programming)

matlab program for beginner

一维粒子滤波算法先建立状态模型和量测模型，再构造粒子滤波函数，通过统计分析得到估计后的状态变量，就是该算法的基本原理(One-dimensional particle filter algorithm to first establish a state model and measurement model, and then construct the particle filter function to be estimated by statistical analysis after the state variables, that is the basic principle of the algorithm )

某型火箭的弹道仿真 包含GUI操作界面、ode函数文件、调用ode的主调文件(Trajectory simulation)