TMS320DM6446 platform, the programmer NAND FLASH procedures and easy to use.

这个程序运行在CCstudio平台上，所用语言为c语言，完成的功能是电机pwm死区变换-This program runs in CCStudio platform, the language used for the c language, the completion of the function is to transform motor pwm dead zone

一个TMS320　5402与51芯片，其中以51来自举的程序．软件　是CCS打开．有兴趣看一下．用51驱动TMS320 5402-TMS320 5402 with a 51 chips, which held 51 from the procedure. CCS software is opened. Are interested in reading about. Drivers with 51 TMS320 5402

设计一套由 CPU 开环控制的单相可控整流装置电网同步信号在进入单片机A/D端口之前，经过了两级运放和RC低通滤波，因而造成2ms的延时，相当于相角滞后了π/

一个巴西人写的控制无刷直流电机的程序，适用于TI公司的TMS320F2812开发板。我自己试了一下，完全可以用。-A Brazilian written procedures for control of brushless DC motor for TI" s TMS320F2812 development board. I have tried it, can use.

IIR（无限冲激相应）滤波器的DSP实现-IIR (Infinite Impulse accordingly) filter implementation of the DSP

经典的DSP程序,仅供学习使用。这是从网上找来的，里面的程序都是可以直接用的，请大家只做学习参考！谢谢！-program

DSP控制器及其应用》中文电子书，涉及DSP系统的总体结构、片内外设、指令系统、应用实例等内容，是一本不错的工具书。-DSP controller and its application " Chinese e-books, involving the overall structure of DSP systems, on-chip peripherals, instruction, application examples and other content, is a good tool.

dm642下的saa7114解码芯片的驱动程序-dm642 the saa7114 decoder chip Driver

基于DSP2407的CAN程序，用C语言编写，使用INT5中断完成-DSP2407 of CAN-based procedures, using C language, the use of complete interruption INT5

dm642通过网络接收烧写文件，然后烧写到flash当中，无需flashburn。此工程是从dm642_5a中copy过来的，加上了boot代码，为的是生成hex文件，烧在flash中，可以独立的运行。-dm642 receive through the network programmer, and then the flash programmer, the need for flashburn. This project is a copy from the back of dm642_5a, together with the boot code, for hex files are generated, burning the flash, you can run an independent.