STM32的FSMC驱动TFT液晶显示屏

有遥控的温度计,用dS1302做时钟芯片，Ds18B20做温度芯片-There are remote thermometer with clock chip DS1302 do, Ds18B20 do temperature chip

c51串口通信程序-C51 Serial Communication Program

利用传感器将模拟信号转成数字信号.列举常用的ADC0809并详细讨论A/D在单片机系统中的应用.-The use of sensors to the analog signal into digital signal. ADC0809 commonly cited and discussed in detail the A/D in SCM systems.

示例程序下载关于单片机接上-download examples of SCM connected

C8051F020单片机的AD测试程序，很好的哦！直接移植便可啦！-C8051F020 MCU AD test procedure, Oh good! Transplant will be able to direct it!

/* 程序详细功能介绍： *当按下按键P3.3 ，AT89S51单片机产生“叮咚”声从P3.2端口输出 *程序设计方法 * 1． 我们用单片机实定时/计数器T0来产生700HZ和500HZ的频率，根据定时/计数器T0，我们取定时250us， * 因此，700HZ的频率要经过3次250us的定时，而500HZ的频率要经过4次250us的定时。 * 2． 在设计过程，只有当按下SP1之后，才启动T0开始工作，当T0工作完毕，回到最初状态。 * 3． “叮”和“咚”声音各占用0.5秒，因此定时/计数器T0要完成0.5秒的定时，对于以250us为基准定时2000次才可以。 */-/* Procedure detailed functional Introduction:* When pressing the button P3.3, AT89S51 Singlechip a

IIC测试程序-IIC test procedures

mage 16L eeprom的经典程序-mage 16L eeprom classic procedure

模拟交通灯，并带有数字显示的程序。初始时全为红灯，显示“HELLO”字样。然后交通灯以“红绿、红黄、绿红、黄红”四种状态做循环，而且黄灯会闪烁，每种状态都带有到数记时。当按下P3_2时，变成“红红”状态，并显示“STOP”字样！ -simulated traffic lights and figures with the procedure. When all of the initial red, shows that the "hello" words. Then traffic lights to the "black, red and yellow, green, red, yellow red" state to do four cycle, but the yellow light flashes, each state will have a few to remember when. When pressed P3_2, into a "red" state, and shows that the "STOP" word!

使用W77e58读写PCF8563时钟芯片，包含所有的子函数，均可以直接使用。-Use W77e58 literacy PCF8563 clock chip that contains all of the subroutine, can be used directly.