一个针对320240液晶的ZLG/GUI移植，没有使用液晶控制器，利用LPC2103端口直接控制，屏幕会稍有闪烁...

MSP430F149单片机控制122*32液晶C程序-MSP430F149 single-chip control 122* 32 LCD C procedures

crc快速校验程序,对于新手很快就能看懂的,结合实际读一读友好处!-Fast CRC checksum procedure, for the novice to understand quickly, and in light of the actual read friendly Office!

采用sja1000开发can总线的源代码-USE SJA1000 DESIGN CAN-BUS SOURCE PROGRAM

cd4094驱动程序，驱动1位共阴极数码管，pic12c508a作为控制器，gp0-gp2分别为data,clk,strobe.-cd4094 drivers, driving a total digital cathode tubes, pic12c508a as controller, gp0-Day for data, clk, strobe.

SJA1000的驱动函数,can功能函数。-SJA1000 drive function, can function function.

工业控制源程序！采用STEP 7 编制！涉及到PROFIBUS-DP组太！-Industrial control source! Prepared using STEP 7! Related to PROFIBUS-DP group too!

这是一个电子电位器源代码,内有两种程序,一个是通过位操作,另一个是通过地址总线操作-This is an electronic potentiometers source code, there are two procedures, a bit through the operation, and the other is through the address bus operation

Keil C51 上51系列单片机优化的CRC－8 算法。可以自己改其他算式的，包含字节查表，半字节查表，bit计算。很难得的哦。-Keil C51 on the 51 computers optimized CRC-8 algorithm. Other formula can do it ourselves, and look-up table contains the byte, half-byte look-up table, bit computing. Hard to come by Oh.

收集了现行市面上路由器的默认密码，绝对具有参考价值-Collection of the current market, the router" s default password, absolutely with reference value

AT91SAM7S256开发板demo，已验证-AT91SAM7S256 development board demo, verified