ADS1118 ADC驱动代码(stm32)

资源描述系统电源有以下几种管理模式：全功能模式，高频晶振（16M 或者32M ）和低频晶振（32.768K RCOSC/XOSC ）全部工作, 数字处理模块正常工作。 PM1 : 高频晶振（16M 或者32M ）关闭，低频晶振（32.768K RCOSC/XOSC ）工作，数字核心模块正常工作。 PM2 :低频晶振（32.768K RCOSC/XOSC ）工作, 数字核心模块关闭，系统通过RESET,外部中断或者睡眠计数器溢出唤醒。 PM3 : 晶振全部关闭，数字处理核心模块关闭，系统只能通过RESET 或外部中断唤醒。此模式下功耗最低。 将睡眠模式下的CC2530 通过定时器唤醒，观察LED 闪烁现象

ProteusARM2138仿真周立功的ARM开发板-Meritorious service Simulation ProteusARM2138 weeks of ARM development board

C8051F120 与双口RAM及CP200的网络连接,能够将信号传给上位机软件.并且已经商用.

ARM9内核的philip公司的LPC3180初始化SDRAM的驱动代码-ARM9 core philip

msp430 单片机按键试验程序，实现单个按键和多个按键的练习，本程序由C语言编写，实现按键过程是通过函数调用实现的，非常是适合初学者学习。

ARM, MIPS, PowerPC 模拟器-ARM, MIPS, PowerPC emulator

This example program shows how to configure and use the A/D Converter of the following microcontrollers: * Philips LPC 2114/2119/2124/2129/2131/2132/2138/2194 After configuring the A/D Converter, the program reads A/D channel 0 and outputs the converted value using the serial port. To run this program... 1. Select the Device (Project - Options for Target - Device) 2. Build the project (Project - Build Target) 3. Start the uVision Debugger 4. Open the Serial Window (View - Serial Window 1) 5. Click Run (F5) 6. Click on the Toolbox buttons to change input voltages A debug script (debug.ini) creates buttons that set different analog values in A/D channels. As the program runs, you will see the A/D input and output change. Other buttons create signals that generate sine wave or sawtooth patterns as analog inputs. µ Vision3 users may enable the built-in Logic Analyzer to view, measure and compare these input signals grap

W90X900 Stand-alone Library(Non OS Library) Audio function library

用MPS430F149单片机对AD转换器TLV2541的设计与应用  ，附有详细的介绍  ，可以供一些学习者们参考与学习。

ADS下的44B0 UCOS实验例程序，可实现创建3个任务-ADS under the 44B0 UCOS experimental cases, which enables the creation of three task