控制板与串口通信程序 用串口命令让汽缸动作

步进电机驱动程序.... 可以通过改变定时来控制电机速度

本程序用于把串口助手所写内容通过pc发送给单片机，并且由单片机把所写内容发送到lcd上面进行显示，所用单片机为日立系列h83664十六位单片机，实验证明可以准确显示pc上面所写的内容。里面包含各个写lcd的子程-This procedure for the serial written by aides through the pc sent to the microcontroller, and written by Singlechip the above content is sent to the lcd display, single-chip microcomputer used for the Hitachi series h83664 16 microcontroller, Experiments show pc can accurately display the contents of the above written. Which contains a subset of the various write-way lcd

AT91SAM7S256开发板基础demo，已验证-AT91SAM7S256 development board based on demo, verified

程序资料共享 希望大家共同进步 共同努力 加油 ！-Procedures for the sharing of information would like the common progress of the joint efforts of U.S. refueling!

用于8051，基于SJA2000的CAN总线协议的通讯-for 8051, based on the SJA2000 CAN bus protocol communications

直接转矩电机控制，仿真程序，SIMULINK m代码实现-Motor direct torque control, simulation program, SIMULINK m code

介绍单片机中PS/2接口的相关协议，可以使用一般的普通键盘-introduced MCU PS/2 interface of the relevant agreements, can use an ordinary keyboard

单片机做的4*4小键盘，学单片机的好资料，proteus仿真通过，学习的好资料-Single-chip to do 4* 4 small keyboard, learning good information on SCM, proteus simulation adoption, learn good information ...

PCF8563 的驱动程序，用两个普通的IO口模拟I2C总线，包括100KHZ（T=10US）的标准模式选择和400KHZ的快速模式选择，默认11.0592MHZ的晶振-PCF8563 of the driver, with two ordinary analog IO I2C bus, including the extremely low distortion (T = 10US), the standard model selection and 400KHZ fast mode selection, the crystal default 11.0592MHZ

这是一个有关单片机C语言使用的范例，这个范例说明如何使用 Port 1 输出跑马灯 -This is a single-chip using C language examples, this example illustrates how to use the Port 1 output Marquee