登录
首页 » 通信 » bpsk的ber与信噪比关系图的matlab实现

bpsk的ber与信噪比关系图的matlab实现

于 2023-07-04 发布 文件大小:3.97 kB
0 269
下载积分: 2 下载次数: 2

代码说明:

用matlab编写的关于bpsk的ber与信噪比关系的仿真图,通过编译证明结果是正确的。

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • 编程学习资源网站列表。介绍了各门编程语言资料收集地址。...
    编程学习资源网站列表。介绍了各门编程语言资料收集地址。-Programming Learning Resources list of sites. Introduction of the door programming language data collection address.
    2022-02-18 16:21:06下载
    积分:1
  • 一个简单实用的串口讯类
    一个简单实用的串口通讯类-A simple and practical type of serial communication
    2022-05-15 12:47:25下载
    积分:1
  • 实现了CS8900的驱动
    实现了CS8900的驱动-Realize CS8900 driver............
    2023-02-25 06:30:03下载
    积分:1
  • 改进行级联CIC梳状滤波器,带内平坦性好,带外抑制更好
    改进行级联CIC梳状滤波器,通带内平坦性好,带外抑制更好-To carry out cascade CIC comb filter, with passband flatness, and band rejection better
    2022-03-30 00:31:58下载
    积分:1
  • 0. Install the rp
    0. Install the rp-pppoe-software -------------------------------- You should have already done this by the time you re reading this. If not, go back and read README. 1. Set up your Ethernet hardware -------------------------------- First, make sure the Ethernet card you intend to use with the modem is visible to the Linux kernel. Just how to do this is beyond the scope of this document. However, if the card is the only Ethernet card in the system, executing: ifconfig eth0 should display something like this: eth0 Link encap:Ethernet HWaddr 00:60:67:62:31:D4 plust some more lines. Your HWaddr will be different. As long as you see the HWaddr line, your card should be working. DO NOT assign an IP address to the Ethernet card. DO NOT configure the card to come up at boot time.-0. Install the rp- PPPOE-software-------------------------------- You should have al ready done this by the time you re reading this. I f not, go back and rea
    2023-03-02 00:45:03下载
    积分:1
  • Software for serial port comunnication
    Software for serial port comunnication
    2022-12-09 06:15:03下载
    积分:1
  • 机顶盒和数字电视DTV的源代码
    dtv source code for stb and dtv
    2022-01-22 06:26:42下载
    积分:1
  • 2ASK调制与解调
    基于FPGA的2ASK调制与解调系统设计 实现2ASK信号的调制与解调功能,基带数据发送4级M序列,数据率为1kb/s,载波用信号源产生,频率为1MHz,用示波器观察已调波波形。
    2022-03-10 02:52:56下载
    积分:1
  • QPSK号采用CMA算法做盲均衡
    该代码能够实现在多径信道下对QPSK信号做盲均衡,采用的是CMA算法,仿真结果由四部分构成,分别是:均衡前后信号星座图的对比图;均衡后系统的误码率曲线,误差函数的收敛曲线;信道响应。
    2022-04-15 22:56:52下载
    积分:1
  • 小型讯程序的C语言源程序的C语言源程序库,都是C源程序,仅用于学习....
    小型通讯程序的C语言源程序的C语言源程序库,都是C源程序,仅用于学习.-Small communication program of the C language source C language source code library, is C source code only for learning.
    2022-05-19 03:52:00下载
    积分:1
  • 696516资源总数
  • 106914会员总数
  • 0今日下载