桌面控制程序，可以隐藏桌面等。

一个相当好的文本编辑器，能实现所有的功能。-One very good Text Edit tool. it have nice functions.

VC++中用Thunk机制实现浮动控件的源码-VC Thunk floating control mechanism to achieve the source

利用Visual Basic编写的小程序，将一款小巧的时钟放在桌面上显示时间。-The use of Visual Basic procedures for the preparation of small, will be a small clock on the table to show time.

进程管理系统设计-process management system design

Priorities: 1) Keep It Simple 2) Do not couple to any specific unit test framework. - use appropriate IdTest.pas units to plug into required framework. Units are named IdTest*, so they can be easily searched/listed. eg using UnitExpert (http://www.epocalipse.com/downloads.htm) ctrl-u, "idtest", lists all available test units. -Priorities: 1) Keep It Simple 2) Do not couple to any specific unit test framework. - use appropriate IdTest.pas units to plug into required framework. Units are named IdTest*, so they can be easily searched/listed. eg using UnitExpert (http://www.epocalipse.com/downloads.htm) ctrl-u, "idtest", lists all available test units.

This the sorce code in Visual Basic 6 for the EMU8086 processor simulator. -This is the sorce code in Visual Basic 6 for the EMU8086 processor simulator.

the testament by john grisham

51C 单片机蜂鸣器播放《丁香花》程序，Keil生成hex文件

1、新建一个项目，调整窗口的大小，修改form1属性窗口中的text属性为“抢答器” 2、在form1中添加一个按钮控件。名称分别为button1.button2.button3.并且分别将控件的test属性设置为“1号2号3号”。 3、在form1右侧添加textbox控件，名称为textbox1.将其text属性清空。 4、再次添加一个按钮控件，名称为button4 ,将其text属性设置为“复位”。 5、双击一号按钮，打开代码编辑窗口，添加按钮点击执行代码如图所示。-1, a new item, adjust the window size changes Form1 properties window of text attributes to "Responder" two in Form1 add a button control. Names were button1.button2.button3. Respectively, to control the test attribute set to "on the 1st on the 2nd on the 3rd." 3, in addition Form1 right textbox controls, to name textbox1. Its text attributes emptied. 4 again to add a button control, the name of Button4, its text attribute set to "reset." 5, click the button on the 1st, open source editor window, click the Add button code execution shown in the figure.

这两个程序通过并行（或串行）端口将数据发送到一个7段显示器。可设置的参数包括：波特率，奇偶校验，延迟等