c8051f020里面自带的温度传感器的使用程序，经调试通过。-C8051F020 own temperature sensor inside the use of procedures adopted by the debugger.

USB鼠标,单片机的,可以-USB mouse, SCM can be

l298调 速 程 序 常规的接法是这样的，EnableA接PWM信号，Input1输入正反控制信号， Input2是Input1经过反相以后的信号。L298的电平是与TTL电路相兼容的，一般是超过2.5V就为高电平。假如Input1为高电平时电机正转，那么低电平时就是反转，PWM信号控制电机的转速。 _________________ -l298 procedures conventional speed connection that is the case, EnableA then PWM signal, Input1 input positive and negative control signals, Input2 is Input1 through after RP signal. L298 level is compatible with TTL circuits, and is generally more than 2.5V for the high. If Input1 is high when the motor is transferred, then that is when low-level inversion, PWM signal to control motor speed. _________________

1.ARM芯片LPC2148的RTC源码 2.ARM芯片LPC2148的DS18B20C驱动源码 3.ARM芯片LPC2148的TIMER0中断驱动源码-LPC2148 chip 1.ARM the RTC source 2.ARM the LPC2148 chip DS18B20C drive LPC2148 chip 3.ARM source of Timer0 interrupt-driven source

利用51单片机实现sle4442的读写，可以使用-51 Singlechip sle4442 realize the use of reading and writing, you can use

一个已经作成过成品的MON51的电路原理及PCB 图。-make an already finished off the MON51 Principle and the PCB circuit map.

pc端usb下载程序DNW的源代码，配合开发板usbd程序可以实现pc和开发板互通-usb client pc download the source code of DNW, with the development board can USBD pc and realize mutual development board

UCOS――FOR――UNSP2，ucos在凌阳单片机上的移植。-UCOS-- FOR-- UNSP2, Sunplus CENTER SCM in the transplant.

本程序是用于通用同步和异步串行接收器和转发器（ＵＳＡＲＴ），使用中断方式异步接收和发送数据通信源的程序文件。-this procedure is common for serial synchronous and asynchronous receiver and transponder (USARTs), the use of asynchronous interrupt receive and transmit data communication source program files.

硬件协议栈芯片w3100a的web－server，用51单片机，keil51环境-hardware protocol stack chips w3100a web-server, with 51 microcontroller, keil51 environment