使用P 1斜坡模式启动pSC1

51单片机驱动DSB20单总线温度传感器-51 Single-chip driver DSB20 single bus temperature sensor

HT44780 液晶显示驱动 里面有简单 程序和说明-HT44780 driver inside the liquid crystal display has a simple procedure and description

pic18f2480的can模块初始化函数以及基本的收发操作-can the pic18f2480 module initialization function, as well as send and receive basic operation

72段LCD驱动器SD0418的测试程序-72 LCD drive SD0418 test procedures

MSP430 串口通讯 利用查询实现，经运行通过-MSP430 serial communication using Query, running through

本程序是通过单片机进行电机的控制，可以控制电机的转速，前进和倒退。单片机通过串口接收来计算机的控制信号(可以采用无线方式进行串口的通讯)。工具采用的是“韦福”的仿真软件。-this procedure through the MCU for motor control, control of the motor forward and retrogression. SCM through the computer serial port to receive the control signal (which can be used for wireless serial communications). Tools used the "ru" simulation software.

用L298作为驱动器，控制两相混合式步进电机。 按键从上至下分别为减速，加速，正转，反转，停止。 具体参数还没有设定过。速度有些慢，加速按2下有效，然后就不能再快了。 转速输出是按照最小系统版的数码管写的。电路图里太麻烦就没画了。-Using L298 as the drive to control two-phase hybrid stepping motor. Buttons from top to bottom respectively, deceleration, acceleration, are being transferred, reverse, stop. Specific parameters have not yet been set. Some of the slow speed, speed up by 2, effectively, and then can not be faster. Speed output is in accordance with the minimum system version of the digital tube wrote. Circuit where not too much trouble drew.

51单片机做的 红外遥控 内含有仿真 是PROUUE 的仿真-51 single-chip infrared remote control to do contain PROUUE simulation is the simulation

Keil　C的调试经验-Keil C debugging experience

ｕｃｏｓ－ｉｉ在ａｖｒ单片机上的移植源代码。实用GCC编译器-CENTER-ii avr SCM in the transplant source code. Practical GCC compiler