Shenzhen vision Magic s DM642 (model VMD642_A) the schematic diagram

绝对好的源码，DM642上实现了H264算法，在CCS 上编译通过 NO ERROR-Definitely a good source, DM642 achieved H264 algorithm, compiled in the CCS, through NO ERROR

DSP54XX很好的学习资料，里面有很多源程序，对初学者很有帮助。-DSP54XX good learning materials, which a lot of source code, useful for beginners.

基于矢量控制的永磁同步交流伺服电机控制系统 可以用的源程序-Based on vector control of permanent magnet synchronous AC servo motor control system can use the source code

DSP 的全套资料，很辛苦收集来的哦，对初学者有很大的帮助-A complete set of DSP data collected is very hard Oh, to be very helpful to beginners

DSP 320F2812 CUPTIMER

卡尔曼目标跟踪算法的源代码选好状态方程和观测方程是关键

将 AD芯片（ADV7183） 采集到的一帧数据 进行处理的程序。 处理源为 ITU656格式 entire field 模式下的整帧数据。 程序输出 每一行的EAV SAV信号坐标、 图像数据字节数， 以及整帧的前10和后10个字节数据， 同时生成TXT文件记录这些信息。 最后将处理源转换成BMP格式输出 -The AD chip (ADV7183) collected data for a treatment procedure. ITU656 format to deal with the source of entire field mode of the entire frame of data. Procedures for each line of output signal EAV SAV coordinates, number of bytes of image data, as well as the entire frame of the top 10 and after 10 bytes of data, at the same time generate TXT file record such information. Finally, the treatment source into BMP format output

DSP2812下,C调汇编的128点FFT程序,算法为TI提供,定点,测量信号频率和幅度较好,速度比C快三倍左右.-DSP2812 under, C tune compiled 128 points FFT procedures, algorithms for TI to provide, point, measure the signal frequency and amplitude is better, faster than C for about three times faster.

利用DSP芯片上的自带ADC模块，进行采集，转换成数字信号，代码简单易懂，有利于读者学习，可以进一步巩固ADc采样方面的知识，程序已经试验过，准确无误

dsp的fir滤波的核心汇编程序，在ccs集成开发环境中运行调试通过 。-dsp core of the fir filter assembler in ccs integrated development environment to run through the debugger.