完全实用化的020 SMBUS程序（与时钟PCF8563通信）.rar经调试,很正确的....

可以用单片机做一个卡-SCM can be used to do a card

spi prog for mcu ok in keil C

isd4003的驱动程序,主要用于驱动isd4003的录放,很有用的啊-isd4003 drivers, mainly for the driver isd4003 recorders, very useful ah!

TLC5615的10位AD转换程序,C直接调用汇编-TLC5615 10-bit AD conversion process, C direct call compilation

一个单片机驱动红外通信的程序,很有意义.当然你也可以举一反三,用作无线通信,也可以仿照该程序做蓝牙通信协议-A single-chip driver infrared communications procedures, meaningful. Of course you can learn by analogy, for wireless communications, modeled on the program can also do Bluetooth communication protocol

MT8880单片机控制的测试程序-MT8880 SCM control testing procedures

HT1621 是一款128 个位元的LCD 控制器件，内部RAM 直接对应LCD 的显示单元。相应的软件使它适用于包括LCD 模块和显示子系统在内的多功能应用。主控制器与HT1621接口只需4 到5 根线。内置的省电模式极大的降低了功耗。本文介绍HT48R05A-1 单片机来控制HT1621，并介绍如何turn ON 及turn OFF LCD 所有位元。-HT1621 is a 128-bit LCD control device, the internal RAM directly correspond to the LCD display unit. So that it applies to the appropriate software, including LCD modules and display sub-systems, including multi-purpose applications. Master controller and the HT1621 interface only 4-5 lines. Built-in power-saving mode greatly reduce power consumption. This article describes the HT48R05A-1 microcomputer to control the HT1621, and describes how to turn ON and turn OFF LCD all the bits.

公共汽车报站器,基于51-bus stop-based 51

MSP430框架程序。适用于MSP430F449，其他型号需要适当改变。 不使用的中断函数保留或者删除都可以，但保留时应确保不要打开不需要的中断。 保留中断函数，编译器将会为BSL密码填充所有的字节。-MSP430 framework procedures. Applicable to MSP430F449, other models need to be properly changed. Do not use the interrupt function can be retained or deleted, but should be retained to ensure that do not open unwanted interruption. Retain the interrupt function, the compiler will fill all of the BSL-byte password.

该文档包含了keilc常用的子程序，共有２５个运算类代码，非常实用．-This document contains commonly used keilc subprogram, a total of 25 computing category code, very useful.