这是一本关于Protel2004的教程,详细介绍了如何使用该软件绘制电路图和PCB板...

为了进一步理解上述方法如何在编程中得以实现，在此提供了1个用C51单片机编程语言编制的8个按键的键处理程序，以供参考。该程序在KEIL C51 V6.02/uVsion2 demo编译环境下编译通过-In order to further understand how the above method to realize programming, provided in the C51 single-chip microcomputer with a programming language produced by the eight key key procedure for reference. The program in the KEIL C51 V6.02/uVsion2 demo compiler compiler environment through

温度测量DS18B20+AT89C2051-temperature measurement DS18B20 AT89C2051

步进电机控制，c版本，proteus仿真-Stepper motor control, c version, proteus simulation

研究了两周的IAP，其中实现了在c++中调用c函数的功能，仅供参考-two weeks of the IAP, which met the call c c of functionality, for information purposes only

C8051F系列CPU，解决128K程序调试例程，用C语言编写。-C8051F series CPU, resolve 128K program debugging routines, using C language.

实现多个数字滚动，移位显示，当按下某个按键时，会将对应于端口的数值送入低位数码管显示-To achieve more than the number of rolling, shift display

采集端程序，可以搜所电信号，每次可以采集32个信号，可以用于检测信号好差。-acquisition software, can be found by the electrical signal that can be collected each 32 signal can be used to detect bad signal.

用C51语言开发，相当有趣，附详细文档及硬件电路图-with C51 language development, very interesting, with detailed documentation and hardware circuit

用SmartGen生成一个256*8的大小同步FIFO，并通过串口发送数据初始化FIFO。然后，再通过串口返回到上位机的串口调试程序显示，确认数据是否正确。-SmartGen generated with a size of 256* 8 Synchronous FIFO, and sending data through the serial port to initialize FIFO. And then back through the serial port to the PC serial port debugger display to confirm the data is correct.

单片机的程序，欢迎探讨-Microcomputer Program, welcomed the study