PIC16F877应用的AD转换主程序 并可以通过LCD显示

单片机AT90S系列 制作简易USB接口（软件模拟,无usb硬件）。- Monolithic integrated circuit AT90S series manufacture simple USB connection (software simulation, non- usb hardware).

温度传感器用单总线DS18B20，CPU为2051，三个按键，分别为UP，DOWN，SET温度调节上限为125度，下限为-55度。-Single-bus temperature sensor DS18B20, CPU for 2051, three buttons, namely, UP, DOWN, SET temperature regulation maximum of 125 degrees,-55 degrees for the lower limit.

】本文介绍了一个使用单片机和CPLD联合控制步进电机的方案。首先阐明步进电机的工作原理及控制方法，然后 提出了系统的软硬件设计框架，详细讨论了单片机和CPLD的逻辑接口问题和交换数据的协议，以及用状态机来设计脉冲分配器 的方法。-This paper describes a combined use of SCM and CPLD stepper motor control program. First of all, to clarify the working principle of stepper motor and control method, and then put forward a system of hardware and software design framework for a detailed discussion of the MCU and CPLD logic interface issues and data exchange agreements, as well as the use of state machine design Pulse Distributor methods.

ARM7开发板的USB源程序，好东西咯。 -ARM7 development board

LCD图形显示函数，很使用！-LCD display function, is used!

本程序是msp430单片机的UART模块的典型示例，对于初学者很有用-This program is msp430 microcontroller UART module typical example, is useful for beginners

AVR单片机的电机测速程序，利用ICCAVR编译，通过ICP测出电机的转速并通过数码管显示和串口上传-AVR MCU electrical velocimetry procedures, take advantage of ICCAVR compiled by ICP measured motor speed and through a digital display and serial From

嵌入式通用EEPROM读写程序.-embedded EEPROM read and write common procedures.

CC2430 基础实验十一 1/3AVDD的实验-CC2430 11 experiments 1/3AVDD the basis of the experimental

PCA捕获功能原程序代码,初学单片机有用,代码已运行过,能用.-PCA capture the original program code, beginner Singlechip useful, the code has been in operation, and can be used.