ppc860的ucos part

说明：  基于stm32f1的 ucosII开发手册 包含移植、代码讲解等(UcosII development manual based on stm32f1 Including porting, code explanation, etc.)

ucos在三星s3c44b0上的LCD程序-OUT Samsung in the LCD s3c44b0 procedures

移植到UCGUI上的汉字库12x12-transplanted to the 12x12 Store

UCGUI 的一些原代码和演示例子。 就的可以的话发表你的评论-UCGUI some of the original code and demo examples. It could then express your comments

这是三星公司arm9 2410编写的音频驱动程序，采用codewarrior编写(This is the preparation of Samsung arm9 2410 audio driver, used to prepare codewarrior)

uc/os2.52在ARM44b0移植成功的代码，已验证-The successful source code of the uc/OS 2.52 port to the ARM 44B0 ,and being tested

ucOS + ucGUI 人机界面 源码 加入触摸屏校准功能。 >> 校准后触摸屏参数保存在STM32芯片自身的Flash中。 >> 当第一次启动程序或者全部擦除芯片后第一次启动将会执行校准。 >> 也可以在设置功能中选择“触摸屏校准”手动执行校准，前提是当前触屏参数和真实值相差不大，可以进入到触摸屏校准选项(ucOS+ ucGUI HMI experiment source Code)

uCOS-III V3.03.01 uCOS-II V2.92.07在STM32F2移植

UCOSIII 移植到 NXP LPC1768 纯净版。 方便大家其它功能的添加。 现在只是点亮LED灯。 添加串口，网口等功能正在进行中，有机会上传啦。(UCOSIII NXP transplanted to the LPC1768 version of pure. Add to facilitate other functions. Now just lit LED lights.)

UCOS-II FOR STM32F103XX 1 本程序是我自己移植，只使用KEIL进行过软仿真，测试没有发现问题。支持从任何一个中断服务程序里释放信号量。 2 此代码作为参考和学习使用，如果在使用过程中造成损失，本人不负任何责任。 3 此代码作为参考和学习使用，因为里边有UCOS-II，如果要作为商业使用请给UCOS付费。-UCOS-II FOR STM32F103XX 1 This procedure is my own transplant, carried out using only soft KEIL simulation, testing did not find the problem. Support from any one of interrupt service routine release semaphore. 2 of this code as a reference and learning to use, if in the use of the process of loss, I no responsibility. 3 of this code as a reference and learning to use, because inside has UCOS-II, if we as a commercial use, please pay uCOS.