AT8091 C51 4*4键盘 程序例子，配电路图

单片机系统用c语言编写关于两个PIC之间的通信的设计。。。本程序采用的单片机型号为PIC16F8- Single-SCM systems c language on the communication between two PIC design. . . This procedure used for the PIC16F877 microcontroller model

C8051F040 SMBUS/// /////主机接收调试程序-C8051F040 SMBUS//////// receiving host debugger

1302时钟芯片的pic程序，完全可以应用在其他的单片机上（不过好像如果速度太快的要改一下）-1302 clock chip pic procedures can be applied to other MCU (But if the pace seems too fast to change it)

51单片机开发的8道门出入记录控制板，具有RTC时钟功能，同时具有声光抱紧，能实时的记录被监控门的打开时间。本案例只有8路，但可以方便的扩展至32路。-51 MCU development of 8 door access control panel recorded with RTC clock function, both sound and light to hold fast, can be monitored real-time record of the time the door opened. This case is only 8-way, but can be easily extended to 32.

使用单片机C8050F330对无线发射接受模块进行配置与控制,使组件成为一个无线通讯中的基站.-The use of single-chip wireless C8050F330 launch module configured to receive and control, so that components into a wireless communications base station.

《单片机C语言编程与实例》的代码,使用keil编程环境,供大家参考- Microcontroller C programming language and examples of code, using keil programming environment, for your reference

采用XC164CS的CAN系统解决方案，详细介绍了对TWINcan的开发套件-XC164CS using the CAN system solutions, detailed introduction on the development kit TwinCAN

C51只提供长整形除以长整形数据，现已经有函数（经过长期验证）6字节数除以整形数据。-C51 only provide long-divided by a long plastic plastic, are already function (with a long track) 6-byte data divided by plastic.

如文件名，在LPC2138上的I2C的Master发送接受测试程序。里面的readme.txt（英）有详细说明。-If the file name, in the LPC2138 on the Master send I2C tested procedures. Inside the readme.txt (British) has a detailed description.

电子定时器的设计 有程序的具体实现和功能描述 好的程序-electronic timer with the design of specific procedures to achieve good functional description and procedures