关于AD采样的MCS51源程序，很有价值借鉴

再分享一个数字万用表的源码， 这也是我从我朋友那里要过来的-Again to share the source of a digital multimeter, which is where I learned from my friends to come

source code for avr

基于at89c2051的方波发生器，MAIN: MOV SP,#60H 设置SP指针 MOV R0,#50H 显示缓冲区首地址时50H ML0: CLR A MOV @R0,A 显示缓冲区清零 INC R0 CJNE R0,#55H,ML0-AT89C2051 based on the square-wave generator, MAIN: MOV SP,# 60H Set SP pointer MOV R0,# 50H shows that the first address buffer 50HML0: CLR A MOV @ R0, A display buffer cleared INC R0 CJNE R0,# 55H, ML0

一些常见的单片机实例，并提供程序源程序，供初学者下载学习。-Some common examples of single-chip, and provide procedures for source code download for beginners to learn.

8051 codeswapmaterial

液晶屏显示程序，主要对各按键处理做了很好的处理，可随意改动各按键，通讯采用MODBUS ASCII 可以控制台达变频器的起停及速度控制-LCD display program, the main keys to deal with a very good, may be arbitrarily changed the keys, communications using MODBUS ASCII converter can console cease and the speed control

16*64位点阵点 阵显示汉字程串口输出字符数据，P2口输出行扫描信号,P0_0输出595锁存信号-16* 64 dot matrix display Chinese characters lattice-serial output character data, P2 mouth output signal scanning, P0_0 595 latches the output signal

周立功串口通讯,附调试软件...可以参考学习下.-Week Ligong serial communications, with debugging software ... can refer to learn under.

用SPCE061A控制两个电机画任意直线的程序。 -SPCE061A controlled by two motors draw a straight line of arbitrary procedures.

lcd 与C51 的驱动程序 1、本实验箱采用的液晶显示屏内置控制器为SED1520，点阵为122x32，由两片SED1520组成，由E1、E2分别选通，控制显示屏的左右两半屏。-LCD C51 and a driver, the use of experimental boxes LCD screen embedded controller for SED1520, to 122x32 dot matrix, composed of two SED1520, E1, E2 respectively strobe control screens around two semi-screen.