基于51单片机的1602显示的计算器，没有附电路，如有需要请与shenchangwei945@163.com联系...

zlg sd card for ucos

本设计的由单片机控制的自动加料系统是与料斗式干燥机配套的加料系统。根据加料工艺要求，其工作原理是：先将真空管关闭，启动电机，用低真空气流将塑料树脂粒子送入真空管，电机停转，再将粒子排入料斗，如此循环。-The design of single-chip microcomputer controlled by the automatic feeding system with hopper dryer feed supporting system. Charging process in accordance with the requirements of its working principle is: first vacuum tube to close, start motor, using low vacuum plastic resin particles will flow into the vacuum tube, the electrical switch to stop, and then particles into the hopper, and so the cycle.

模拟串口C51编程-simulation C51 Serial Programming

控制电机的程序，pwm控制速度程序等等都有-Motor control procedures, pwm speed control procedures, and so on have

单片机读写MMC卡的详细C代码（包括SPI和MMC模式）-SCM MMC card reader detailed C code (including model and MMC SPI)

24C02的读写时序和源码，经测试能用，可以向24CXX推广。-24C02 timing and source of reading and writing, can be used by the test can be made to promote 24Cxx.

遥控编码分析软件，可以分析多种无线波形,可以节约很多金子啊-Remote control code analysis software, can analyze a wide range of wireless waveforms, can save a lot of gold ah

zigbee是门新型的技术，将在未来的社会中扮演着重要的角色，特此提供Jennic zigbee中文开发指南-zigbee is a new type of door technology, society in the future play an important role, and would like to provide Jennic zigbee Chinese Development Guide

TI Stellaris LM3S9B96 的 Datasheet，该 MCU 使用 ARM 公司 Cortex-M3 内核，为新的一代 MCU。-TI Stellaris LM3S9B96 the Datasheet, the MCU to use ARM" s Cortex-M3 core, as a new generation MCU.