PIC

键盘控制页面显示。屏蔽一些键盘事件。F1.F2.F3控制不同显示模式。-jianpan

t6963c控制液晶程序,包含完整的源程序和文档说明-LCD t6963c control procedures, including complete source code and documentation

东芝T6963控制芯片的240128点阵液晶屏驱动程序-Toshiba T6963 controller chip of the 240,128 dot-matrix LCD driver

T89c51cc01的CAN通信子程序，C代码，可在keil 下编译运行-T89c51cc01 CAN communication subroutine, C code, the compiler running under Keil

俄罗斯方块程序 ,本压缩包里面含有原理图和远程序(Proteus),-Russian box procedure, the compressed packet inside contains schematic and far from the procedure (Proteus),

SPMC75F2413A单片机在AC变频空调中的应用-Singlechip SPMC75F2413A in AC inverter air conditioner application

用loop51实现的可调式脉冲发生及检测器，可以手动输入所发生脉冲的频率和占空比，实时检测及动态显示-loop51 achieved with adjustable pulse and the detector, which can occur manually input pulse frequency and duty cycle, real-time detection and dynamic display

是对sd卡驱动的分析以及读写分析寄存器配置-Is the sd card-driven analysis and analysis of reading and writing configuration registers

IC卡操作软件:AT88SCl604芯片的操作模式有五种。它们是通过配PGM、RST、CLK等引脚信号及内部地址计数器(IAC)的状态组合来实现。 (1) 芯片复位操作： AT88SCl604有两种复位方式:上电复位和控制复位。 上电复位： 上电复位是当芯片加电时的最初状态。上电复位属于芯片 内部复位。它将使芯片内部所有的隐含标志复位到"0"状态。并使地址计数器复位到0位。 控制复位： 当CLK为低时，在RST脚上的一个下降沿将便芯片产生复位操作。 控制复位是将地址计数器复位到0位，而不影响任何内部标志的状态。-IC Card operating software : AT88SCl604 chip mode of operation there are five. They are allocated by PGM, RST, etc. pin CLK signal and the internal address counter (IAC) portfolio of the state is to be achieved. (1) chip reset operation : reduction AT88SCl604 two ways : power-on reset and reset control. Power-on reset : power-on reset when the chip is in power at the initial state. Power-on reset the internal chip is reset. It will enable all internal chip implied signs reset to "0" state. Make address counter reset to 0. Reset control : When the CLK for the low, the RST feet of a falling edge chips will have to reset operation. Reset control is to address counter reset to 0, without prejudice to any signs of internal sta

ts1620液晶显示的驱动，这种驱动网上一般很小有，是我自己写的并通过了测试-ts1620 LCD driver, which drives the Internet is generally very small, yes, I wrote it myself and passed the test