课设的模式识别算法，matlab源代码

射频功率放大器的数学建模，采用saleh模型在matlab环境下进行代码编写(hebavioral model of RF amplifier)

一个简单的例程，对仿真信号使用RLS算法进行自适应滤波(A simple routine of simulated signals using RLS adaptive filtering algorithms)

利用粒子滤波进行电机的参数估计，包括电机的各项电流、位置、速度。(Particle filter motor parameter estimation, including the motor current, position, speed.)

关于均匀线性阵列中阵元个数和阵元间距的matlab仿真例程(About a uniform linear array and the array element number of the array element spacing matlab simulation routines)

三角级数法求路面时域模型，并应用pwelch方法求其功率谱密度，与标准路面功率谱密度进行对比(Trigonometric series method is used to solve the time domain model of pavement, and the power spectral density of pavement is calculated by pwelch method, which is compared with the standard pavement power spectral density.)

说明：  回波数据进行二位FFT处理结果和CFAR处理后结果对比(Comparison of the results of two-bit FFT and CFAR processing for echo data)

说明：  这是一个基于最大信息判据的盲源分离算法程序，这个程序能很好的分离信号。(This is a criterion based on the maximum information algorithm for blind source separation procedures, which can be a very good signal separation.)

说明：  matlab入门的基础知识,很好用的,看完后你就懂了(Introduction to the basics of matlab, very good use, you will get it after reading)

simple coding for dwt dct svd matlab

这是一个关于OOK的代码编程，有兴趣的读者可以关注一下！！！(OOK)