This design through the VC and PC software to control stepper motor program

采用dspic30f2010的变频器核心驱动程序,程序可以实现正转/反转,频率设定,保护等-the inverter used dspic30f2010 core drivers, procedures can be achieved is to/inversion, frequency creation, protection

CAN上位机通讯程序vb与单片机通信时用的上位机程序 -CAN PC communication program vb and MCU communication procedures used in PC

一个可调小时分钟的数字钟系统，先是在液晶屏上，显示开始为00：00：

ARM环境使用的SD卡驱动和FAT16文件系统读写源代码-ARM environment for the use of the SD card drive and FAT16 file system to read and write source code

凌阳IDE中写的一个交通灯控制程序，改一下自己的IO代码 直接编译就可以使用了-Sunplus IDE write a traffic light control procedures, to your own direct IO code compiler can use the

基于Proteus的交通灯控制系统，带16*2LCD和4*4键盘，可对交通灯切换时间进行设定，以及紧急状态等的设定-Based on the Proteus of the traffic lights control system, with 16* 2LCD and 4* 4 keyboard, available on the traffic lights switch time settings, as well as a state of emergency settings, etc.

单片机C程序设计完全手册.关于单片机的非常有用的书-Microcontroller C Programming full manual

PTR8000的一个调试程序，功能还可以。-PTR8000 a debugger, functions can also be.

FlashFlex51单片机

有关74hc080的一些相关资料，希望可以帮助大家，它多用于IC卡读取了！-74hc080 some of the relevant information, I hope can help everyone, it used the IC card reader!