CSTN 用IC ST7636R

用C实现信号发生装置：1、正弦波：频率、幅度可调。 2、三角波：频率、幅度可调。 3、方 波：频率、幅度、占空比可调。 4、按键：波形切换、频率调节、幅度调节、方波占空比调节。 5、显示：信号的频率、幅度，在方波时还要显示占空比。 -Implementation using C Signal: 1, sine wave: frequency, amplitude adjustable. 2, triangle-wave: frequency, amplitude adjustable. 3, square wave: the frequency, amplitude, duty cycle adjustable. 4, button: switch waveform, frequency regulation, rate regulation, adjust the duty cycle square wave. 5, show that: the signal frequency, amplitude, when they showed at the duty cycle square wave.

51事例原代码 事例多多 应该对初学者很有用-51 examples of the original code examples should be more useful for beginners

C51单片机做的驱动四线程马达的驱动程序,用于步进电机驱动!-C51 microcontroller do drive four threads motor driver for stepper motor drives!

可以设置温度报警上下限。具有输出脉冲脉宽可调节的数字温控仪。-Temperature alarm can be set upper and lower limits. The output pulse width can be adjusted with a digital temperature controller.

本文详细系统地介绍了uC/OS-II 在51 单片机上的移植、重入实现方法、硬件仿真、固化、人机界面等关键内容。-paper detailed and systematic introduction of the Phone/OS-II in 51 MCU transplant and re-entry method, hardware simulation, curing, the man-machine interface and other key elements.

msp430F149 ADC12模块程序-msp430F149 ADC12 module procedures

pc与51单片机的快速串行通信程序。开发环境KeilC-pc with 51 single-chip fast serial communication program. Development environment KeilC

用于两单片机利用串口通信。有完整的原理图、仿真、程序。-For the use of two single-chip serial communication. A complete schematic, simulation, process.

此程序是用AVR单片机编写的驱动SD卡的源代码，希望大家能够喜欢！-this procedure is used to prepare the AVR SD card driver source code and I hope we can like!

跑马灯流动闪亮控制程序，可按键控制启动、停止、改变流动方向等。-Marquee mobile flashing control procedures, key control can start, stop, change the flow direction.