UDP

这是XMODEM传输协议原代码,测试只能证明错误的存在，而不能表明程序中没有错误。 测试的两个作用是：确定程序中缺陷的存在；有助于判断该程序在实际上是否可用。 软件测试最困难的问题之一是知道何时停止测试(When to stop testing? ) 自己测试自己的程序是不可能的。 当一个软件被测出的缺陷数目增加时，更多的未被发现的缺陷存在的概率也随之增加。 -This XMODEM transfer protocol source code, the test can only be proved wrong there and not show anything wrong procedure. The two test role is : procedures for determining the existence of defects; Contribute to the judge whether the procedure can be used in practice. Software testing the most difficult one of the problems is to know when to stop testing (When to stop testing) testing their own procedures is not possible. When a software detected the increase in the number of defects, more undiscovered flaws in the probability has increased.

采用Log-BP算法的LDPC码译码仿真程序，给出了不同信噪比下误码率和误包率的统计图，用matlab和C（c-mex）程序分别编写，有详细说明和注释。-The use of Log-BP decoding algorithm for LDPC code simulation program is given a different signal to noise ratio and bit error rate under the packet error rate of the statistical map, using matlab and C (c-mex) procedures, respectively, to prepare, has a detailed description and notes .

寨手机网采购网，绝对好用真实，代码完整，亲测！-MOBIEL

Cadence SPW 4.8.2，viterbi解码的源码。-Cadence SPW 4.8.2, the Viterbi decoder source.

信号编码与译码中的二值图像游程编码算法的Matlab实现，谢谢~-Signal encoding and decoding the binary image run-length coding algorithm Matlab implementation, thank you ~

基于MATLAB的OFDM信道估计算法，使用了PN序列作为导频，两种导频处信道估计处理方法，中间特别加入了相位估计处理-MATLAB-based channel estimation algorithm for OFDM using PN sequence as a pilot and two pilot channel estimation Department treatment methods, particularly the middle to join the treatment phase estimation

基于ZIGBEE协议通讯的开关程序，仅供参考-ZIGBEE agreement on the switch communications procedures for reference

rfc1157 for used for developing mib in snmp

Unlocking the Power of OPNET Modeler一书，最新出版的教材，经典的源代码，不容错过

涉及指示灯驱动管脚,蜂鸣器驱动管脚定义,AD的状态显示,AD的选中信号,延迟子程序-involving light-pin, buzzer-pin definition, the state AD, AD selected signal delay subroutine