这是一个基于8051单片机的用c语言写的一个时钟程序，个人原创哦...

注:protel电路图 1.INPUT12为高压气压和低压压传感器输入端. 2.OUTPUT为充气输出控制端. 3.当高低压有接地信号时,电机正转,气阀打开. 4.INPUT2低气压时有信号时,充气OUTPUT输出,充气电机转. 5.RS1与RS2是调节阀门距离用地 6.RS3是与气阀电机同步时,是气阀电机的转动圈数传感器. 7.RS4是调节延时时间用地-Note: protel circuit 1.INPUT12 and low-voltage high-pressure pneumatic pressure sensor input. 2.OUTPUT output control for the inflated side. 3. When the high and low pressure have a grounding signal when the motor is transferred, the valve opens. 4.INPUT2 low pressure when there is signal output OUTPUT inflatable, inflatable motor switch. 5.RS1 and RS2 is the regulator valve from the land 6.RS3 synchronous motor with the valve, the valve motor is rotating circle the number of sensors. 7.RS4 delay time to regulate land

本书是嵌入式系统不可缺少的工具

Philip tea 5767 FM 驱动用应用程序 char FM_Init(char bandinfo, char softlev) -Philip tea 5767 FM applications driving char FM_Init (char bandinfo, char softlev)

基于Small RTOS51的数据采集器设计-Small RTOS51-based Data Acquisition Design

TFT液晶控制程序 -TFT LCD control procedures TFT LCD control procedures TFT LCD control procedures

基于单片机的数字频率计设计，定时器T0完成定时功能，T1采用计数功能-MCU-based design of digital frequency meter, timer T0 timing finish, T1 using count function

pic16f877与pc通讯，（源代码）-dsPIC and communications, (source code)

这是一个接收单片机数据的软件,通过对接收的数据分析来显示相应的LED.目前只能显示一个LED,有时间会全部做好的,目前接收到的数据为0A0B0C,也就是从单片机发出来的数据为10,11,12,单片机的程序是a-This is a single-chip microcomputer software to receive, through the analysis of data received to display the corresponding LED. Currently only display a LED, will all have time to do a good job of currently received data 0A0B0C, that is, from a single machine sent to the data for 10,11,12, SCM process is a

keil下驱动程序的编写，VC-the driver prepared, VC

代码为单片机与液晶模块的接口电路程序以及显示程序，适用于用单片机实现液晶模块显示的初学者-Code for the microcontroller and LCD module interface circuit procedures and display program for display LCD module with MCU for beginners