FM1702的13.56M RFID读写程序

单片机的程序，关笑喇叭报警用的，大家过来看看啊，说不定有用。-SCM procedures, customs police used loudspeakers laugh, we had来看看啊might be useful.

1线通讯协议的c51例子程序, 已调试通过-One-line communication protocol procedure example of the C51 has been debugging through

Msp430的flash读写文件配置文件，(msp430f427芯片)-MSP430

义隆单片机读写24C** ** 24CXX 接口I2C总线读/写的程序 ** （所有时序均基于4MHZ晶体震荡器频率）-Elan Single-chip 24C**** 24CXX read and write I2C bus interface read/write procedures** (All timing are based on the frequency of 4MHz crystal oscillator)

30路遥控开关,按0-30个键分别点亮p0.0-p3.5的灯,32键全灭 可以用此外接驱动后控制30路开关！ 遥控器端口p3.7-30 Road remote control switches, keys, respectively, by 0-30 months p0.0-p3.5 lit the lamp, 32-key body can also take control of 30 after the driver switch! Remote control port p3.7

51系列单片机在基本的开发例程，不错噢。-51 Series MCU in the development of basic routines, Oh well.

两点间的温度控制,５１单片机初学着必须掌握的简单程序-Between two temperature control, 51 single-chip beginner to grasp the simple procedure

用汇编语言写的风扇转速测试程序,用于转速测试,传感器用KEYENCE-using assembly language to write fan speed test procedure for testing speed, the sensor used KEYENCE

ATmega8+315M或433.92M的超再生接收头+1602六线控制的1602显示解到的码-ATmega8+ 315M or 433.92M the超再生receive the first+ 1602 six-lane controlled display solutions to the 1602 Code

1.电子琴功能 用实验板上K1~K7作为电子琴的7个按键，每个按键对应一个音符要求当按下其中一个按键，就通过P2.5口输出对应频率信号使蜂鸣器发出特定音符声音。 2.乐曲演奏 若按下K8键，完成自动弹奏“送别”歌曲。 -1. Organ function of the experimental board K1 ~ K7 as the organ of the seven buttons, each button corresponds to a note of which require that when the press of a button, on the adoption of P2.5 port output frequency signal corresponding to a specific note to the buzzer sounds . 2. Music playing, if pressed K8 button to complete the auto-play " Farewell" songs.