本程序是C语言编写的,由 步进电机驱动的指针式温度表,反应灵敏,指示精确....

PID-REGULATOR FUNCTION "C" SOURCE CODE

nrf905无线开发 调试原代码 和51通信-Wireless Developer nrf905 debug the original code and 51 communications

编写一个延时1MS子程序根据题目选择是定时还是记数状态，本题选择记数状态。然后根据延时1MS计算出计时器的初值是E0H（高8位）18H（低5位）。最后编写算法，对T0初始化，利用T0的中断TF0调用中断处理程序。-prepared a delay rungs subroutine under the topic chosen is not a time to memorize numbers or state of mind of the few options that state. According to delay timer rungs calculate the initial value is E0H (high 8) 18H (Low 5). Preparation of the final algorithm, the T0 initialization, interrupt the use of T0 TF0 call interrupt handling procedures.

LT_1B msp430开发板例子程序－UART15_096-LT_1B msp430开发板例子程序－UART15_09600

CMEL奇美光电2.8寸OLED屏的SPI初始化程序 配置为RGB工作模式-init CMEL 2.8 OLED by SPI interface

motorola单片机68hc908gr60的LIN总线驱动程序，编译环境Codewarrior，经验证可以使用--Motorola s 68hc908gr60 LIN driver. It is compiled and verified under Codewarrior.

ZLG500B读卡模块数据传输协议--底层函数和高级函数-ZLG500B reader module data transfer protocol-- the bottom and Senior Function Function

AVR单片机的EEPROM的读写程序, 通过TWI接口读写.-AVR MCU EEPROM reading and writing process, reading and writing through the TWI interface.

单片机上智能拼音输入法,附有控制和杳询函数.方便使用调用.可以自加LCD实现可视化键盘输入!供大家参考!-microcontroller smart Pinyin input method, with the control and with the enhancement of function. To facilitate the use of call. Since the LCD can be added to achieve visual keyboard! For your reference!

利用单片机以及DA0832产生正弦波的C51源程序-As well as the use of single-chip generated sine wave DA0832 source of C51