周立功smartarm2200板子RTC例子

An assembly to strobe the LEDsvia Port D. The strobe rate is to be set by adjusting the voltage drop over a potentiometer that is sampled by an ADC

嵌入式实时操作系统ARM的开发-ARM embedded real-time operating system development

飞利浦 LPC系列ARM7 SPI演示程序 基于永探电子开发板-Philips LPC series ARM7 SPI demo program permanent exploration of electronic-based development board

支持各种FLASH，著名的烧写FLASH的软件，flashpgm-support FLASH, the famous burning FLASH software flashpgm

用于制作JTAG 下载器的重要芯片介绍，是它的PDF文档-JTAG download the browser for the production of an important chip introduction, is its PDF document

采集AIN0和AIN1的信号，通过可调电阻，使输入的模拟信号发生改变，来进行A/D转换。为保证数据的准确性，通常采集10次以上，在求平均值。A/D转换器采集AIN0和AIN1的信号,并显示出来。-AIN1 acquisition and AIN0 signal, through an adjustable resistor, so that the analog signal input to change, to carry out A/D conversion. In order to ensure the accuracy of the data is usually collected 10 times more than the average in the order. A/D converter and acquisition AIN0 signals AIN1 and displayed.

此示例演示如何配置微机电系统 accelerometre 来检测加速度 X / Y 轴，以检测的单击双点击 Z 轴。程序启动后检查了 MEMS accelerometre 状态寄存器和行为，如下所示： 1.如果审计委员会移动加速检测到，则 x / Y 轴和指示灯切换根据的运动方向和速度。2.如果单击检测到，则 Z 轴 LED3 和 LED6 切换期间 3s。3.如果双击在 Z 轴上检测到所有指示灯都切换期间 3s。

TI DSP2812 can总线程序,可以用这个程序设计can总线收发数据,已经在自己的开发板上测试过,运行良好-TI DSP2812 the can main line procedure, may use this programming can main line receiving and dispatching data, has already tested on own development board, the movement is good

arm架构的说明，比较详细的一个文档-arm structure of the note, a more detailed document

针对立于泰开发板的嵌入式开发文档，给初学嵌入式的人更多资料！-Thailand for an embedded development board to develop a document for learning more information embedded!