这是基于ATMEL89S51上的一个电子时钟源代码程序,有相当完美的注释解说,希望对大家有所帮助....

sja1000驱动源代码-sja1000 driver source code

RC500开发全套资料,内有详细经过测试详细资料。-RC500 development of a full set of information, which has been tested in detail more details.

开发环境为keil166，使用xc164cs从can接收数据 在串口定时发送-Development environment for keil166, the use of xc164cs from the serial port can receive data sent from time to time

使用PROTEUS仿真的RS232串行通信口,可在串口助手输入,激活7段数码管显示相应的数字-PROTEUS simulation using RS232 serial communication port, serial port assistant in the input, activation of 7 digital tube display the corresponding figure

STM32F103VBT6 实现 norflash 功能-STM32F103VBT6 realize norflash function

msp430单片机控制完全时钟程序,这个程序太好用了,欢迎高手来交流-MSP430 single chip microcomputer to control fully clock procedures, which spent too good to welcome you to share

C8051F04x单片机可变周期PWM脉宽调制。-C8051F04x Singlechip variable pulse width modulation PWM cycle.

I2C总线基本操作函数,及几个对I2C总线接口器件24C04操作的函数。 -I2C bus basic operation function, and several of the I2C bus interface device to operate a function of 24C04.

本程序用于用单片机控制步进电机的转动。用单片机的某一个引脚实现控制，如果引脚电平为高则实现正转，反之为反转。所用单片机为日立系列h83664十六位单片机。本代码使用c语言实现，开发环境为日立系列单片机专用开发环境-This procedure for the use of single-chip stepper motor rotation control. With a pin MCU control, if the pin level is higher then realize to the contrary, for the inversion. Used in single-chip for Hitachi Series 16 Singlechip h83664. This code uses the c language, development environment for the Hitachi series of single-chip dedicated development environment

用CY7c6300驱动LED的源程序,经过验证,绝对能用P0口LED到VCC就可以.-with CY7c6300 drive LED source, proven, I absolutely can use P0 LED VCC to be.