本代码主要是利用ftr2401组态编程，使用飞思卡尔…

一个I2C为驱动的一个时钟芯片程序，很有用的，大家好好学习吧-A I2C-driven one clock chip procedures, very useful, you study hard everyone

VHDL编写的八位9值信号的中值输出方法，特点是不采用流水或状态机设计，因此速度较快-VHDL prepared by eight of the nine value signal output value method, which is characterized by not using water or state machine design, therefore faster

单片机实用子程序-Singlechip practical Subroutine

51单片机驱动DHT11温湿度传感器并成功在数码管上显示，压缩包内有驱动后的照片。-51 MCU-driven DHT11 temperature and humidity sensors and successfully in the digital tube display, compression packages have driven after photos.

单片机汉明码编码程序，8-4编码，编码后得数据通过串口发送出去-Singlechip hamming code encoding process ,8-4 encoding, the encoded data sent through the serial port

本程序是一个将CanOpen协议的通讯转换为TTL串口通讯(9600,e,7,1),CANOPEN的站号是9-This procedure is a communications protocol will CANOpen convert TTL serial communication (9600, e, 7,1), CANOPEN station is No. 9

ISD4003-4M语音的详细使用说明，和ISD4003-4M的技术资料！-ISD4003-4M detailed voice instructions, and ISD4003-4M technical information!

状态1：正常时，8个LED发光二极管（彩灯）循环点亮。 • 状态2：有报警时，蜂鸣器发出报警声（用P3.3接一个按键，模拟产生报警信号。当开关合上，发生报警；当开关断开，报警停止。用P3.7输出音频信号驱动扬声器，作为报警信号），同时8个LED发光二极管（彩灯）闪烁。 P3.2接一个按键，用于消除报警-Status 1: normal, eight LED light-emitting diodes (lantern) light cycle.

微机键盘和单片机的接口程序,采用了上升沿触发中断服务程序,下降沿触发中断服务程序.-computer keyboard and microcontroller interface procedures using the rising edge trigger interrupt service procedures, falling edge triggering a break in service procedures.

威帆电子的精密时钟SD2303的读写程序-Granville sails of the sophisticated electronic clock read and write procedures SD2303