一个在UCLINUX环境下实现的PING程序，用C编写

革新GX-ARM9-2410EP WinCE工具-Innovation GX-ARM9-2410EP WinCE Tool

Linux操作系统开始在移动电话上得到应用 -Linux operating system began to be applied on mobile phones

嵌入式图形处理系统,emgui嵌入式图形处理系统,-embedded graphics system, emgui embedded graphics system,

2440 cpu test

本段代码实现了uc/osII系统在51单片机上的移植，uc/osII系统是一种实时多任务的操作系统，可以在多种平台下实现移植，而51单片机是其最简单的移植平台，对其硬件的要求RAM>256,在实验代码中，我们实现三个任务实时进行切换。

本程序是显示模块的例程，所接器件为四位八段led数码管，其中PTB0-PTB3 与数码管的位选相连接，PTB4，PTB5与74LS164连接确定你开发板上拨码开 关JP1（图片上的12）的两位和JP4（图片上的9）的5、6、7、8位处于on）， 而其他位处于远离on！-This procedure is the routine display module, the access device for four eight led digital tube, which PTB0-PTB3 bit digital tube and connected to the election, PTB4, PTB5 with 74LS164 sure you connect the development of on-board DIP switch JP1 ( picture on the 12) two and JP4 (picture on the 9) of 5,6,7,8 located at on), while the other located at far away from the on!

有关的线路连接  GND – GND, VCC – 3.3V, CS – D8, CSN – D9, SCK – D10, MOSI – D11, MISO – D12, IRQ – D13 这个测试程序是发射端不断发送0x00到0XFF的数据给接收端

这个是有关存储ic的集合,包括eeprom,flash,ram等等,相信对做硬件的朋友是很珍贵的资料-This is the id of the storage pool, including EEPROM, flash, ram, etc., I believe that friends do hardware is very valuable information

C51遥控测试程序,电路已经认证合格,请多提意见-C51 remote control test procedure, the circuit has been certified, please do so

NorFlash的烧写及相关说明可以通过串口实现程序的在线升级-NorFlash the programmer and the related notes can achieve the program s online serial upgrade