uCOS_II for MSP430 (kernel source and portable document)

Source Code for ZigBee PIC18RF Module

ucos51单片机经典实例程序ucos51 classic instance of the SCM process(ucos51 classic example of SCM procedures ucos51 classic instance of the SCM process)

本人自己移置的ucosii2.76代码，适用于lpc22xx,lpc21xx，目前已经在实际项目中使用，代码中提供有建好的项目。开发环境为ads1.2。-shift their own ucosii2.76 code applies to lpc22xx, lpc21xx, now in the actual use of the project, code for the project is completed. Development environment for ads1.2.

uCOS-II向三星S3C44B0x处理器的移植源代码.

KEIL 下的UCOSII移植，里面有LED的点灯，点灯是需要按一下按LED灯亮一下，还有串口，不过波特率不准，只实现接收进入中断，其实就是完成了中断进入、信号量创建，对初学者十分有用。此例子用的是KEIL公司的MCB2300开发板，和英蓓特的LPC2300一样，原理图可以在KEIL公司官网上下到。-KEIL under UCOSII transplantation, there are LED

44b0豪华板使用的ucos2+ucgui-44b0 luxury plate used ucos2 ucgui

uCOS 下LCD的驱动控制,完全源码,放心使用-for uCOS LCD driver under control, complete source code, the use of confidence

最初学习单片机的时候，由于条件，没有硬件，就只好用Proteus仿真，其实效果蛮不错的。到后来的高版本，直接可以支持ARM。相当不错的工具。此源码是其对uCOS在ARM上运行的仿真。-MCU when the initial study, due to conditions, not hardware, they can use Proteus simulation, in fact, quite a good effect. Later versions of the high direct support ARM. Pretty good tool. This source is its uCOS running in ARM emulation.

ucgui下的GIS引擎简陋版，采用ucgui为绘图GUI,演示GPS坐标与屏幕坐标变换，实现轨迹回放功能，放大缩小功能，不能演示，但也具有，没完善-GIS engine under ucgui simple version, using ucgui for mapping GUI, presentation screen GPS coordinates and coordinate transformation, achieve trajectory playback, zoom function, not presentation, but also not perfect

这是基于UCOS的LCD显示驱动，LCD为RGB+SPI模式。希望对大家有用。(This is LCD driver based on UCOS，the model of LCD is RGB+LCD.Wish help for you。)