PC serial port for the next bit plane data by mass, to achieve bi

very good c program for software-very good c program for software77

单片机控制网络芯片进行通信 （内容包括rtl8019as的驱动程序，uip协议栈，电路原理图，tcpip.h文件，pic单片机通过8019as进行通信的完整论文）-SCM control network chip communication (including rtl8019as driver, uip stack, circuit schematics, tcpip.h file, pic microcontroller to communicate through 8019as the full paper)

本程序是用 ATmega16 控制实时时钟芯片 DS12887 接口驱动的源程序文件。-this procedure is used to control real-time clock ATmega16 DS12887 interface-driven source files.

用单片机和数码管，构成数字时钟。可以设定时间和闹钟。-MCU and digital control, constitute a digital clock. Can set the time and alarm clock.

此程序实现无线信标定位，GPS产生的信号经过（7，4）汉明码编码后发送，接收端解码得到发送端坐标。程序分为发射和接收2部分，在Keil C下编译实现。-This procedure positioning wireless beacons, GPS signal generated by (7,4) hamming code is encoded to send, receive decoding client coordinates to be the sending end. Transmitting and receiving procedures are divided into 2 parts of the Keil C compiler under implementation.

ADC0809驱动程序，可以直接使用。 我在实验中已多次使用过。-ADC0809 driver can be used directly. In the experiment I have used.

C8051F040的步进电机调试程序，频率计算公式为:(T3时钟频率/(2*val-C8051F040 debugger stepping motor, the frequency of the calculation formula is: (T3 clock frequency/(2* val

适用于51单片机的万年历算法.rar-applied to the MCU 51 calendar algorithm. Rar

S3C2440 arm9芯片上RTC的测试程序，可以测试RTC是否正确运行，以及能对RTC进行时间设置。-RTC chip S3C2440 arm9 test procedures to test whether the RTC correctly, and be able to set the RTC time.

利用VC提供所的MSCOMM控件实现了单片机和微机之间的串行通信，经调试已经成功-VC to provide the use of MSCOMM control and realize the single-chip serial communication between microprocessor by commissioning has been successfully