这是我自己做的１６０２液晶，包括ＰＲＯＴＵＥＳ原理图，希望对大家有用。...

uClinux下用的数据库-uClinux using database

使用G726编解码的VOIP语音数据包的源码.-The use of G726 codec VOIP packet voice source.

Linux下SDIO设备的驱动程序，可以移植到其他系统如ucos上面-Linux under the SDIO device drivers, can be transferred to other systems such as the above uCOS

虚拟uart ,有了它,你不要再连接硬件了,也不用去受硬件没连好的痛苦了. 你可以在没有硬件的环境下很方便的调试uart-The virtual uart, With it, you will not be connected to the hardware, and is not taken up by the hardware, not even a good pain. You can no hardware environment is very convenient to debug uart

IIC协议程序，该程序时IIC协议的驱动，通过该程序可以访问IIC协议的器件-IIC agreement procedure, the program IIC protocol-driven, through which the program can access the device IIC Protocol

这是基于altera的片上处理器nios 的一个IP电话终端的设计,来源altera的电子设计文章大赛.-This is based on the altera-chip processor Nios an IP telephone terminal design, the source of the electronic design altera article contest.

lcd模块化编程，类比驱动一样注册，添加等，增加代码的移植性

嵌入式界面 菜单移植  STM32上移植的ucgui  ,方便菜单编写，字库随意更改；可以先用VC在PC机上进行模拟测试。

MIPS Assembly Language Programming

用STC89C58单片机做的数据采集和控制，12位AD转换使用TLC2543，通讯协议采用MODBUS（RTU），通过拨码开关改变从机地址，支持模拟量或数字量的读写。（4路模拟量输入、6路开关量输出（继电器输出）、8路开关量输入） 开发环境:KEIK 7.06 -STC89C58 SCM done with the data acquisition and control 12 AD switch TLC2543, MODBUS communications protocols used (RTU), Switching to allocate yards from the plane to change addresses, support analog or digital literacy. (4 analog input, six-channel switching output (output relay), eight-way switch input) development environment : KEIK 7.06