MICROCHIP 公司的 ENC28J60 网络芯片的技术文档。

应用背景AdHoc网络是无线网络为代表的基础设施网络。在20个节点或站在NS2 Adhoc网络。关键技术 ；AdHoc网络仿真网络模拟器2.35。

通讯编程过程中,有时需要得到MAC地址,本文说明,取得系统中网卡MAC地址的三种方法,有源代码说明.-communications programming process, and sometimes require MAC address, the paper stated that made system MAC addresses of the three methods, the active code note.

1)生成2KHz和8KHz的混合信号，使该信号通过上述滤波器，观察滤波前后的波形变化和频谱分布情况。 2) 在改信号中加入高斯白噪声，观察滤波前后的波形变化和频谱分布情况3) 将上述滤波器改为中心频率为100KHz的带通滤波器，信号源为带外的90KHz和带内的100KHz的混合正弦信号，。 4) 用M文件实现上述低通滤波器。 -1) 2KHz and 8KHz to generate the mixed-signal, so that the signal through the above-mentioned filter, filter before and after observation of the waveform and spectrum distribution of the changes. 2) add to the signal in white Gaussian noise was observed before and after filtering and spectral waveform changes in the distribution of 3) will be replaced by the above-mentioned filter center frequency of 100KHz band pass filter, the signal source for the band and the band of 90KHz 100KHz Sine of the mixed signals. 4) achieve the above-mentioned documents with M low-pass filter.

计算机通信MC35接收软件-MC35 receiving computer communication software

中移mm7api，开发移动彩信的必须，连同接口文档一起，供开发移动网关的朋友下载，希望能提供给你帮助-China Mobile mm7api, development of mobile multimedia must be, together with the interface documentation, together with a friend for the development of mobile gateway to download, hoping to provide you with help

TMS320VC5502 example code for AIC23 and usb

VC++环境下用MSComm控件进行串口通讯编程 模型飞机测控平台-VC++ Environment MSComm controls with serial communication programming model aircraft monitoring and control platform

The file is for MAP decoding. You can use matlab to open it.

一个用c编的RS编码的程序，采用BERLEKAMP-MASSEY S 算法，输入m,以及信噪比，可得到生成多项式和误码率等。-with a series of RS coding procedures, using BERLEKAMP- MASSEY S algorithm input m, and the signal-to-noise ratio. available generating polynomial and the error rate.

NS2中多信道例子程序，实现了multichannel,其中一个实现了multiflow,-