Keil 51下的倒计时， 秒表程序

LT_1B msp430开发板例子程序－Comparator

crc校验源码，可供C51程序员参考，我目前测试用的32位CRC程序-crc check source code, programmer"s reference for C51, I am currently testing 32-bit CRC procedures

用单片机I/O口模拟总线形式的通用驱动程序，用C51编写-MCU I/O simulation generic form of bus drivers, prepared with C51

利用PWM产生高精度正弦波,从PWM引脚输出的脉冲信号经过简单的低通滤波后,可以得到平滑的正弦波,波的频率可以微调-produced using high-precision sine wave PWM, PWM output pin from the pulse signal through simple low-pass filter, can be smooth sine wave, the wave frequency can be fine-tuned

avr单片机atmega8系列led显示测试程序，本程序为示例程序，适用于初学者 -avr microcontroller series led atmega8 testing procedures showed that the procedures for sample procedures applicable to beginners

使用MSP430F413的低功耗水表系统，在空闲时电流3.5uA-The use of low-power meter MSP430F413 system idle current 3.5uA

单片机实时多任务交通控制程序。 包括ABSTRACT.TXT、GETLINE.C、README.C、SERIAL.C、TRAFFIC.C、等代码源文件-Single-chip multi-task real-time traffic control procedures. Including ABSTRACT.TXT, GETLINE.C, README.C, SERIAL.C, TRAFFIC.C, such as source code files

常用串行EEPROM的编程应用，SPI总线(Serial Peripheral Interface串行外围设备接口总线)是三线式的串行总线，是由摩托罗拉公司所研发，使用三线进行数据传输，分别是SCK时钟引脚，SI数据输入引脚和SO数据输出引脚。-Commonly used application of serial EEPROM programming, SPI bus (Serial Peripheral Interface Serial Peripheral Interface Bus) is a three wire serial bus is developed by Motorola, the use of third-line data transmission, namely the SCK clock pin, SI data input pin and the SO data output pin.

步进电机驱动，简单使用，只需稍加修改，即可用于你想到的系统-Stepper motor-driven, simple to use, just a little modification, you can think of for your system

51系列单片机的uCOS-II原代码-51 Series MCU uCOS-II source code