AVR驱动18B20例子 AVR驱动18B20例子

基本原则qrwrfewtrrgvcdgf-sasefdhgdfgyjghjk

这个软件是设置时间的程序。可以把时间设置在寄存器中保存。-The software is set up time-consuming procedures. Time settings can be saved in the register.

利用单片机仿真JTAG测试驱动程序,可做测试烧录等-The use of single-chip JTAG emulation test driver, do the test burn, etc.

122*32 点阵 st7920 lcd中英文显示 串行驱动程序-122* 32 dot matrix display in both Chinese and English st7920 lcd serial driver

使用的是arm单片机LPC2210，进行AD 转换，使用ADC模块进行电压测量，有多个程序模块-use of the arm LPC2210 MCU for AD conversion, ADC module for use voltage measurement, there are a number of program modules

功能：实现对DS18B20的读取 原理：单总线协议 注意：单总线协议对延时要求比较严格，此程序中采用的是11.0592M的晶振，如果使用其他的晶振请跟据DS18B20的资料修改延时参数-functions : to achieve DS18B20 read Principle : single-bus protocol attention : single-bus protocol to delay requirements more stringent, this procedure is used in the crystal 11.0592M if the use of other crystal please According to the information DS18B20 delay parameter changes

c51程序库，汇编写的，希望对大家有点用。-C51 libraries, compiling written, in the hope that a bit with everyone.

智能计数器，对外部信号脉冲进行计数，并将脉冲个数显示出来。 基本要求：计数至少65536个脉冲，并将脉冲个数显示出来。 -intelligent counter, the external signal pulse counting, pulse number will be displayed. Basic requirements : at least 65,536 Count pulse, and pulse number displayed.

直接转矩电机控制，仿真程序，SIMULINK m代码实现-Motor direct torque control, simulation program, SIMULINK m code

(AD9958用ADuC845控制的keil源代码包,键盘和显示部分在另一个板上，通过串口发送指令和返回数据) 线路图在压缩包内-(AD9958 using ADuC845 control keil source code package, keyboard and display part in another on-board, through the serial port to send commands and return data) circuit diagram in the compression bag