该程序运行在CCStudio平台，使用的语言为C语言，日…

 ALIENTEK 战舰 STM32 开发板本身并没有触摸屏控制器，但是它支持触摸屏，可以通过外接带触摸屏的 LCD 模块（比如ALIENTEK TFTLCD 模块），来实现触摸屏控制。在本章中，我们将向大家介绍 STM32 控制 ALIENTKE TFTLCD 模块，使用软件模拟 SPI 来实现对 TFTLCD 模块的触摸屏控制，最终实现一个手写板的功能。

This the code using PIC MCU to control -This the code using PIC MCU to control CC1 1

ds18b20温度测量 ds18b20温度测量-DS18B20 Temperature measurement Temperature measurement DS18B20

本程序主要是是s3c2410关于iic总线对rtc时钟的控制。开发环境是ads1.2-This procedure is the main S3C2410 on the IIC bus on the rtc clock control. Development environment is ads1.2

关于2407的头文件以及一些c语言的例程-2407 on the first document as well as some language routines c

his project was built and tested with WinAVR-20060125. Make sure the MCU target define in the Makefiles corresponds to the AVR you are using!! To build the code, just install WinAVR and run "make" from the console in echomaster and echoslave subdirs. "make program" will program the device if you have a AVRISP attached. Remember to set the AVR device to at least 8MHz. The AVR may use the programmable clock from MC1319x, just remember to check if the MC1319x and SPI communication is working FIRST! Otherwise you wont get any clock signal to the AVR and then you can t program it or reset the fuses! The MC1319x has default clock output of 32kHz so you will have to set your programmer to a very low frequency (

这是ARM处理器S3C2410对实时时钟编程的原代码-This is the ARM processor S3C2410 on real-time clock programming source code

arm 存储管理系统mmu的中文翻译版本，学习arm的可以看看的-arm MMU memory management system of the Chinese translation version of the study can look at the arm of the

USB通信源代码，适合LPC214X的USB开发。-USB communications source code for the USB development LPC214X.

基于s3c44b0x的小车控制程序，通过按键扫描判断不同方向指令，进而发出相应的PWM波驱动电机以及控制电机转动方向的I/O信号，采用中断实现换挡调速-Based on the car S3C44B0X control procedures, through the different buttons to scan to determine the direction of instruction, and then issue the corresponding wave PWM motor drive and control the direction of motor rotation of I/O signals, the use of interrupted realize Shift Speed