485单相电能表开发程序，液晶显示。采用AD7755设计，可与掌上电脑连机通信设置各种电能表参数。...

转化为控制指令，然后每50ms通过串口向上位机发送一次命令，上位机收到数据后控制虚拟仿真机器人，最后，上位机收集虚拟机器人的姿态参数，再通过串-Translated into control commands, and then every 50ms upward through the serial-bit machine to send a command, the data received after the host computer to control the virtual simulation robot, finally, the collection of Virtual PC robot posture parameters, and then through the string

ADC7841 为12位4通道串行AD转换，本程序为SPCA061A为CPU 扩展ADC7841-ADC7841 for 12 4-channel serial AD converter, the procedures for SPCA061A for CPU expansion ADC7841

51系列单片之间的串口多机通信程序。已经成功通过调试，可以可靠通信。-51 Series single-chip serial port between the multi-machine communication program. Has successfully passed the testing can be reliable communication.

通讯设置程序，主要是串口通讯子函数和控制数据流。-Communications setup program, mainly Serial Communication Function and control of data streams.

pic单片机程序,用于数制转换,可将16位二进制数转换成5位十进制数.-pic microcontroller procedures for a number of system conversion, 16 can be converted into binary-decimal number five.

msp430 与12864的之间的通信,已经成功调试,不过因为12864的类型不一样,可能不能直接用,你还需要修改一下-12864 between the MSP430 and communications, has successfully debug, but because of the type not the same as 12864, may not be directly used, you also need to make some corrections

单片机与ALTEC温控仪的通讯，设置温度。-Single-chip temperature controller with ALTEC communication, set the temperature.

C51 TIMER 0的使用 Timer_0_mode_0_timer_gate_soft-C51 TIMER 0 use Timer_0_mode_0_timer_gate_soft

该程序用于使CCP1模块产生分辨率为10位的PWM波形，占空比为50 */-该程序用于使CCP1模块产生分辨率为10位的PWM波形，占空比为50*/

功能完善的四层电梯程序。开门停8秒，上升或者下降一层用时5秒，有五秒倒计时数码管，楼层显示数码管，以及电梯内外楼层请求显示灯。-A well-functioning procedures for four-storey elevator. 8 seconds to open the door stopped, increased or decreased when a layer of 5 seconds, the 5 seconds countdown digital tube, digital tube display floor, as well as inside and outside the elevator floor indicator lights request.