5615 10 DA conversion chip C

单片机复位电路的可靠性设计复位电路的基本功能是 系统上电时提供复位信号直至系统电源稳定后撤销复位信号为可靠起 见电源稳定后还要经一定的延时才撤销复位信号以防电源开关或电源插头分-合过程中引起的抖动而影 响复位-MCU reset circuit reliability design of the circuit" s basic function is to reset the system power-on reset signal until the system is to provide stable power to withdraw the sake of the reset signal as a reliable power supply stable even after a certain delay to revoke a reset signal to prevent the power switch or Power plug points- combined jitter caused in the course affected by reset

基于CPLD的二进制码转换为二十进制（BCD）码的电路[1].pdf-based CPLD binary code into two decimal (BCD) code circuit [1]. Pdf

通用的嵌入式设备下载软件--A general-purpose download software for embedded systems.

读写SD卡寄存器和数据,调试成功,直接能用.-SD card read and write registers and data, debug the success of direct use.

石器时代3.0源代码 2008.08.27最新版 完全可编译开服！-Stone Age 3.0 source code for the latest version 2008.08.27 compiler fully open service!

jfs-2.4-1.1.7.tar.gz jfs 2.4－1.1.7 源码， 赶紧下载啊--Source code for jfs 2.4－1.1.7.

调度演算法则的代码。

研华数据采集卡PCI1713,PCI1720,PCL730测试程序-Advantech data acquisition card PCI1713, PCI1720, PCL730 testing procedures

文章的内容是有关嵌入式编程用到的工具-MAKE的中文手册.-The content of the article is about embedded programming tools used in Chinese-MAKE manual.

1）LPC2148开发。开发板是由NEX机器人。链接：http://www.nex-robotics.com/lpc2148-development-board/lpc2148-development-board.html  2）GPS模块：联发科MT3318芯片组的模块链接：  http://www.nex-robotics.com/products/gps-receiver/gps-receiver-mt3318-module.html  3）加速度：MMA8451Q（3轴+/-8克I2C基于加速度传感器飞思卡尔）链接：  http://www.nex-robotics.com/products/sensors/3-axis-digital-accelerometer-with-voltage-regulator.html  4）GSM调制解调器：SIMCOM SIM900a链接：  http://www.rhydolabz.com/index.php?main_page=product_info&products_id=1079