本文件是ATMEGA16A的使用说明，内附该单片机内部各个资源的C代码和汇编代码...

键盘扫描的一种方法经过调试可以运行!键盘扫描的一种方法经过调试可以运行-A method of scanning the keyboard after debugging can run! Keyboard scan after a method of debugging can run

51单片机的一些例子 我用过很好用的又需要的-MCS 51

LT_1B msp430开发板例子程序－UART_U24-LT_1B msp430开发板例子程序－UART_U2400

凌阳061a单片机语音识别使用例程。包括两个基本语音识别例子可识别5条指令-Sunplus 061A routine use of single-chip speech recognition. Includes two examples of the basic speech recognition identifiable Directive 5

pic 16f87x pic 16f87x

msp430f169 双线uart模式驱动12864-msp430f169 uart wire mode driver 12864

SH69PXX单片机与24系列E2PROM接口程序包-SH69PXX microcontroller series with 24 E2PROM interface package

视觉暂留，编程从一个I/O口输出一扫频信号，驱动一支LED灯闪动，频率范围为10HZ~99HZ，扫描时间为30秒，在LED闪动期间观察，一旦发现无法识别LED灯闪动时，按下按键K1，立即停止输出，并将此时的信号频率显示在数码管上，该信号的周期为测试者的视觉暂留时间。-Persistence of vision, programming from an I/O port outputs a sweep signal to drive an LED light flashing, the frequency range of 10HZ ~ 99HZ, scan time of 30 seconds, the LED flashing during the observation, once found it impossible to identify the LED lights flashing, press the key K1, immediate cessation of the output, and at this time the signal frequency displayed on the digital control on the test cycle of the signal" s persistence of vision time.

这个程序是控制无线模块2401接受，为51系列单片机控制。可以将接收到的字节上传到电脑的串口-This procedure is to control the wireless module 2401 to accept for the 51 series single-chip control. Can be received bytes uploaded to the computer

在winavr上调试的一个adc程序，可测试。-In a winavr debugging adc procedures, can be tested.