MSP430串行异步通讯实现源程序，这个是一段简单的完整通讯程序，实现功能：将接受的数据原样送回

LPC2378 LCD演示工程源代码，希望大家喜欢-LPC2378 LCD demo project source code, I hope everyone likes

本程序功能是利用单片机控制用户板上的小键盘，将按下的键通过单片机的串口发送给PC机，在PC机串口助手显示出来。用行翻转法的方法来识别输入的键盘。 二、通过单片机将键盘按下的键在LCD上显示出来。 -This procedure is the use of single-chip control functions of the user on-board a small keyboard, the keys will be pressed through the single-chip serial port sent to the PC, the PC Serial Port assistants displayed. Line inversion method used to identify the method of keyboard input. Second, through the single-chip microcomputer keyboard keys pressed on the LCD display.

通过EC的SMBUS接口读取电池信息，如电流、电压、温度等-read battery information via SMBUS in EC interface

MAX232串口与单片机通讯的电平转换芯片，转换后电压在0-5之间-MAX232 serial communication with the single-chip level translator chip voltage conversion between 0-5

这是一个LPC2214 Nand闪存程序，演示如何使用Nand闪存

请将OpenPet.ico 放在c盘文件下 当然你也可以放在程序目录，那就要修改程序 将private Icon img = new Icon(@"C:OpenPet.ico") 改为private Icon img = new Icon("OpenPet.ico") -request OpenPet.ico on c disk Document Of course, you can be put on the directory. it is necessary to revise procedures to private Icon img = new Icon (@ "C : OpenPet.ico ") to private Icon img = new Icon (" OpenPet.ico ")

以上是一些简单的单片机入门教程， 希望可以对刚学单片机的朋友有点帮助-These are some simple single-chip Tutorial, hope that we can just learn a little bit to help a friend SCM

单片机课程设计的LCD显示，附带有程序，仿真图，以及原理。-LCD display, there are procedures, simulation plans, as well as the principle of

单片机T9输入法，原作者不详。-SCM T9 input method, the original author is unknown.

单片机51的剑杆织机程序. 源程序,调试通过.-the Loom procedures. Source code, debugging through.