125khz射频ID卡读卡程序，C51汇编

MSP430F149读写卡参考例程,实现读卡模块和写卡模块的操作。基本例程全在。也可以实现 扣费钱包等功能。(The MSP430F149 read/write card reference routine implements the operation of the card reader module and the card reader module. The basic routines are all there. It is also possible to implement functions such as deducting wallets.)

详细地介绍了RFID现阶段的应用以及发展趋势-Detail the application of RFID at this stage as well as the development trend of

RFID阅读器设计的硕士毕业论文，包含了详细的标准分析，设计框图，代码示例(RFID reader designed master thesis contains a detailed analysis of the standards, design diagram, code samples)

基于STM32的RFID模块的RC522例程(RC522 Procedures Based on STM32 RFID Module)

在工作中曾完成的一个NFC读卡器， 主要使用的ST公司的新推出的CR95HF芯片，做板测试已OK。 对于从事NFC开发的人员绝对是一种值得备用的资料。 （附件提供原理图，CR95HF编程手册，驱动CR95HF的C源代码，另包含有 对双接口芯片M24LR64的驱动） CR95HF芯片有如下特点： 标准频率：13.56-MHz 支持多协议：ISO/IEC 14443 A and B，ISO/IEC 15693，ISO/IEC 18092 提供2种标准接口： SPI 和 UART 。 只需简单的7条指令： (Work was done in a NFC reader, the main use of the ST' s new CR95HF chip board test has to do OK. Personnel engaged in the development of NFC is definitely a worthy alternative information. (Annex provides schematics, CR95HF programming manual, driver CR95HF the C source code, and the other contains the dual interface chip M24LR64 driver) CR95HF chip has the following characteristics: standard frequency :13.56-MHz multi-protocol support: ISO/IEC 14443 A and B, ISO/IEC 15693, ISO/IEC 18092 provides two standard interfaces: SPI and UART. 7 simple instructions:)

transmission signal by 64-QAM and synchronization with cyclic interval

2.4G，RFID电子标签程序，这是经过测试可以用的nrf24L01接收发送程序，应用环境是MSP430F149(2.4G, RFID tag program, which is tested can be used to send program nrf24L01 receiving the application environment is the MSP430F149)

RFID定位算法 基于RFID的室内定位(RFID system)

此代码为RFID中防冲突算法中的固定帧ALOHA算法的仿真(this code for RFID defense algorithm conflict fixed frame ALOHA Simulation Algorithm)

RFID系统有源标签为降低功耗而采取的的低频唤醒机制。-RFID active tag system to reduce power consumption and wake-up mechanism for the low-frequency taken.