DOS环境下,使用Borlandc开发的串口通讯程序

采用win32API用C++BUILDER实现的串口通信，可实现与一般通信设备的AT命令交互- Uses win32API with C the BUILDER realization string mouth correspondence, may realize and the general communication facility AT order alternately

TAPI 编程事例，有兴趣的可以研究．很有价值．-TAPI programming examples are interested can study. Great value.

本程序是i2c总线读写一个字节的程序。在写过程序中，不一定非要检测i2c的应答位，可以直接延时过去就行，但是在读过程中必须给应答信号，读完发停止位，一定确认所发的信号都发上了。否则在连续地址读的过程中可能不会出错，但是在随机度过程中就会出错，我的程序就是在给停止信号时没有给上，24cxx一直在输出数据，结果读出错。找着问题后我的程序只加入了一条命令便完全正常。-i2c bus read and write a byte procedures. The written procedure, not necessarily require the detection i2c-response, and can directly past trip delay, but the process must be read to the response signal, stopped at reading, we recognize the signals are on the fat. Otherwise, the address read for the course could not go wrong, but the randomness of the process would be a mistake, I was in the process to stop for no signal, 24cxx in output data, read errors. I discovered the problem after the procedure just joined the order of a completely normal.

通讯类程序,serialport串口通讯源代码-servail

这是通过COM口对声波触摸屏控制卡进行仿真测试的程序的源码. BCB-through COM ports on acoustic touch screen control card for simulation testing procedures for the source. BCB

早期开发的MS8051与PC的RS232通讯-1程序源码-Early development of the MS8051 with the PC

1、本实验箱采用的液晶显示屏内置控制器为SED1520，点阵为122x32，由两片SED1520组成，由E1、E2分别选通，控制显示屏的左右两半屏。-1, the experimental use of the boxes built-in LCD controller for SED1520, to 122x32 dot matrix, composed of two SED1520, E1, E2 respectively strobe control screens around two semi-screen.

vb语言的串口编程一点滴。-vb serial programming language a bit.

用 VB 写的对云台进行控制，主要用于监控系统的云台控制-VB wrote to the pan-tilt control, mainly for the Monitoring System Console Control

Serial port driver for 8051 chips.