老外写的TS201 LinkPort DMA发送/接收程序，学TigerSharc的可以看看。...

这是测试SEED-VPM642上的RTC与EPPROM的测试程序。-This is a test SEED-VPM642 the RTC and EPPROM test procedures.

TI C5409 IIC 接口程序，利用GPIO,自己实现时序-TI C5409 IIC interface program, the use of GPIO, realize their own timing

dsp5509a 读写SPI25f1024程序, 配合上面的DEvice ID的读取,验证连线是否正确-dsp5509a read and write SPI25f1024 procedures, with the above DEvice ID read, verify the connection is correct

基于H.263的图像压缩编解码的C源码，在CPU为586以上的PC上能够实时完成压缩、解压缩算法，并可以很容易地移植到TI的DSP上-Based on the H.263 video compression codec of the C source, in the CPU for more than 586 of the PC can be completed in real-time compression, decompression algorithms, and can be easily ported to TI s DSP on

继电保护的程序代码很早以前用的。主IC  LF2407A ;12864 图形点阵液晶菜单程序，傅里叶FFT算法程序，继电保护算法，遥信，遥脉，遥控逻辑程序等；可以作为继电保护开发参考，非常实用的代码。

H.264 编解码程序，希望对各位有用，同时加强交流是才主要目标-H.264 codec procedures, in the hope that useful, at the same time to strengthen the exchange is only the main objectives of

合众达开发板的基于dsp的串口通信（spi）源程序调试。-United Development Board of the dsp-based serial communication (spi) source code debugging.

C6000 INTDMA编程指南-C6000 INTDMA Programming Guide

数字信号处理及其matlab实现 （美） Vinay k.ingle john g.proakis著 第四章-Digital signal processing and matlab implementation (U.S.) Vinay k.ingle john g.proakis the fourth chapter

这是用CCS编写的DSP汇编程序，可以实现320TMSC54XXDSP与直流伺服电机定速控制实验 -CCS is used to prepare a compilation of DSP procedures, TMSC54XXDSP 320 can be achieved with the DC servo motor fixed speed control experiment