FlashFlex51 Microcontroller Control of CompactFlash Card in I/O Mode

C8051F的液晶显示程序，主要是解决中文显示问题。值得一看-C8051F LCD procedures, mainly the Chinese that the problem is solved. An eye-catcher

用C语言写的HT1621的驱动程序，非常好的实例。-C language to write the HT1621 the driver, a very good example.

单片机开发的显示电路设计，里面附有C的源代码-The development of the display of single-chip circuit design, which with C source code

pROFIBUS 从站源程序 SPC3 pROFIBUS 从站源程序 SPC3 -PROFIBUS slave source SPC3 pROFIBUS source from the station SPC3

有单片机控制的12864图形显示程序，，有汉字和图形的程序-There are 12,864 single-chip graphic display control procedures, there are Chinese characters and graphics procedures

控制电机运动的G代码程序,如果对G代码不清楚,请先看懂G代码,然后再看本程序.-Control motor movement, G code program, if the G code is not clear, please understand G code, and then look at the procedures.

用C写的I2C总线EEPROM读写程序，在MSP430＋AT24C64～512平台上验证通过。对其他处理器只需简单修改即可使用。-C write I2C EEPROM read and write procedures, the AT24C64 MSP430+ ~ 512 platform validation through. The only other processor can use a simple amendment.

ps2键盘的命令集，编写键盘驱动时有用。EDH:置位/复位 LED 指示器。键盘右上角有三个 LED 指示器,分别反映 Caps、Num 和 Scroll 三个键的 锁定情况。参数字节如表 2 所列。 -ps2 keyboard command set, the preparation of useful keyboard-driven. EDH: Set/reset LED indicator. The upper right corner of the keyboard has three LED indicators, respectively, reflecting the Caps, Num and Scroll Lock keys in three cases. Parameter bytes as listed in Table 2.

包括电路图和源程序，汇编语言编写。JP1、JP2、JP3为电机接口，JP5为投币器接口，JP4为指示灯接口-including circuit diagrams and source code, written in assembly language. JP1, JP2, JP3 for electrical interfaces, JP5 for the coin interface, the interface indicator of JP4

红外线遥控的相关代码及主控芯片的参考资料-Infrared remote control code and master the relevant reference chip