PS/2口向PC发送键盘信息；并通过UART发送

The best firmware for int6000 powerline. ClassB-The best firmware for int6000 powerline. ClassB

基于F020的AD603控制程序，在电子竞赛中， 我也是用这个程序， 可以用，而且其中的F020程序，大家也可以借鉴， 经常可以用到。-very good!

多位数除法程序，满足在单片机编程中对除法程序的需要，解决了单片机指令无除法程序的缺点，而且本程序不限制位数。-over the median divider, which meets in MCU Programming division procedures to the needs of SCM solutions division procedures directive without shortcomings, but the procedure does not limit the median.

这程序是实现单片机与PC机的通信程序 可供大家参考或学习！-MCU and PC communication program for reference or study!

基于AVR单片机的电池容量显示 开发环境 I-Based on the AVR MCU development environment battery capacity display I

MD51-86实现的四人抢答器 -MD51-86 to achieve the four Responder

这是sd/mmc卡程序的第三部分，后面还有！-This is the sd/mmc card the third part of the procedure and there are!

本程序是C语言编写的,由 步进电机驱动的指针式温度表,反应灵敏,指示精确.-this process is the preparation of the C language from the stepper motor-driven pointer thermometer responsive, precise instructions.

基于中断控制的声光报警器的设计.采用中断方式，设计一个声光报警器的硬件电路和控制程序。程序运行时，一旦8位开关信号量状态满足设定条件，就触发中断，使发光二级管按规律闪烁，同时扬声器播放一段音乐。 硬件设备包括一台微机、一个MFID微机实验箱、一块T型板，2输入四与门 74ls08、8位总线驱动器 74ls245、LM386A音频放大器、排阻、扬声器各一个，发光二极管8个，470uF电容2个、104电容4个，插线若干。 -Interrupt-based control of sound and light alarm design. Using interrupt mode, designing a sound and light alarm hardware circuits and control procedures. The program is running, once the 8-bit switch signal to set the amount of state to meet the conditions to trigger interrupts, so that light-emitting diode flashes according to the law, while speakers play a piece of music. Hardware includes a computer, a computer simulation, MFID box, a T plate, 2 input 4 and gate 74ls08, 8-bit bus driver 74ls245, LM386A audio amplifier, exclusion, speakers of a light-emitting diode 8, 470uF capacitor 2 a, 104 capacitors 4, plug-line number.

名称：8*8点阵显示 公司：上海浩豚电子科技有限公司 编写：师访 日期：2009.5 修改：无 内容：和数码管显示方式相同，这里使用P0口和P2口-Name: 8* 8 dot-matrix display Company: Shanghai Electronic Technology Co., Ltd. Hao dolphin prepared: Teachers Visit Date: 2009.5 Review: No content: and digital tube display the same way, where the use of P0 and P2 port port