AD转换器的FIR滤波的语音信号的成就，在TMS320VC5402 DSP…

硬件要求：基于合纵达的SEED-VPM642的示例。软件要求：CCS2.2以上版本。对于想用DSP/BIOS开发的同道中人来说是很好的学习实例。-Hardware Requirements: Based on the combined vertical up the SEED-VPM642 example. Software Requirements: CCS2.2 above. For want to use DSP/BIOS development for the fellow human is a very good learning examples.

用dsp实现的的小波神经网络进行图象识别编程-Dsp achieved using the wavelet neural network image recognition programming

This x-loader program for OMAP3530-This is x-loader program for OMAP3530

外部声源模拟信号经过A/D7865采集器量化后，DSP信号处理器TMS320F28335通过外部扩展口XINTF将数据写入数据缓冲区，进行信号检测，检测到声信号后，再截取信号进行相关处理，估计声信号到达麦克风阵列各阵元的时延差，根据估计出的时延差和当前麦克风阵列的姿态数据解算出目标信息。

DSP algorithm

数字I/O实验主要完成的功能： 在此实验中，SEED-DEC5416 首选进行初始化，包括对外设 UART、本身频率的设定及一些状态区的初始化。然后等待 SEED-MMI5402 发送命令；SEED－DEC5416 响应交通灯自动模式、交通灯手动手动模式、交通灯东西通、交通灯南北通、及交通灯的禁行与夜间模式的操作命令。同时还响应，对 SEED-DEC5416 的复位及两个单元之间的通讯故障。 -Digital I/O completion of the experiment the main features: In this experiment, SEED-DEC5416 preferred to initialize, including peripherals UART, their frequency settings and some of the initialization state of the district. SEED-MMI5402 and then wait to send commands SEED-DEC5416 automatic mode in response to traffic lights, traffic lights manual manual mode, the traffic light east-west pass, pass traffic lights north and south, and traffic lights at night and cut-line mode command. At the same time, also responded to the SEED-DEC5416 reset and communication between two modules fault.

6437的evmdm6437_flash_write例程-evmdm6437_flash_write

配合书籍, DSP 最优秀开发板 hello dsp 2812 的全部例程,

C6713对Flash 的烧写例程，对于做BOOT的人应该很有参考价值-Flash programmer for the C6713 routines for BOOT should make valuable