基于51的pt100铂电阻测温

逐点比较算法，直线插补算法，可以做步进电机运动控制(Point-by-point comparison algorithm)

硬件资源: 1,DS0(连接在PA8)，DS1(连接在PD2上) 2,串口1(波特率:115200,PA9/PA10连接在板载USB转串口芯片CH340上面) 3,ALIENTEK 2.8/3.5/4.3寸LCD模块(仅支持MCU屏) 4,按键KEY0(PC5)/KEY1(PA15)/KEY_UP(PA0,也称之为WK_UP) 实验现象: 通过按键KEY_UP可以控制定时器AutoReloadTimer_Handle的开启，这个是 周期定时器，一旦开启就会不断的运行，直到按下KEY1将其关闭。按下KEY0 可以打开定时器OneShotTimer_Handle，这是个单次定时器，只会运行一次， 运行周期到了以后就会停止运行，除非按下按键KEY0将其再次开启。(Hardware resources: 1, DS0 (connected to PA8), DS1 (connected to PD2) 2. Serial port 1 (baud rate: 115200, PA9/PA10 connected on board USB to serial chip CH340) 3, ALIENTEK 2.8/3.5/4.3 inch LCD module (only supporting MCU screen) 4. Keyboard KEY0 (PC5)/KEY1 (PA15)/KEY_UP (PA0, also known as WK_UP) Experimental phenomena: The timer AutoReloadTimer_Handle can be turned on by keying KEY_UP. This is The periodic timer will run continuously once it is turned on until KEY1 is pressed to turn it off. Press KEY0 You can turn on the timer OneShotTimer_Handle, which is a single timer and only runs once. The run cycle will stop after that unless KEY0 is pressed to turn it on again.)

聊天服务器，输入IP既可聊天，还恨好用，真的不错-Chat server, enter the IP can chat, but also hate use, really good

说明：  stm32驱动TFTLCD的一个程序，带触摸功能，裸机实验(STM32 driver TFTLCD program, with touch function, bare machine experiment)

利用COM组建的实现VC++与MATLAB的混合编程(COM realize the use of established VC++ Mixed with MATLAB Programming)

STM8S官方库2.2版本。。。。。。。。。。。。。。(STM8S official library file version 2.2)

说明：  逆变器的基础模型预测仿真，是电力电子比较先进的控制(The basic model predictive simulation of the inverter is a relatively advanced control of power electronics.)

对数运算的C语言定点程序.rar对数运算的C语言定点程序.rar(Logarithmic fixed-point C-language program. Rar logarithmic fixed-point C-language program. Rar)

DSP2812基于长沙创制电子的mini开发板的实验例程，教你学dsp(DSP2812 development board based Changsha create electronic mini experimental routine, taught you how dsp)

说明：  通过频谱来模拟波浪，程序为Jonswap谱的波浪模拟，可随意调整谱参数、时间间隔和模拟的时间长度(The wave is simulated by the spectrum, and the program is a wave simulation of the Jonswap spectrum. The spectral parameters, time interval and length of the simulation can be adjusted at will.)