05年大学生电子设计竞赛试题《悬挂运动物体》程序

LT_1B msp430开发板例子程序－UART08_096-LT_1B msp430开发板例子程序－UART08_09600

是关于sd卡的接口电路图以及pcb封装原理图 是sd卡驱动者重要的资料-Is on the sd card interface circuit and the pcb schematic package sd card driver is important information

89C51 单片机I_O 口模拟串行通信的实现方法--Simulate I_O serial port communication in 89C51 SCM.

LCD字库生成 ；-LCD font generation

at89c51 读取写入24c64的C源代码-24c64 read write AT89C51 the C source code

BasicCAN 驱动程序-BasicCAN Driver

此程序为单片机编程，主要实现无线收发功能，所使用的无线芯片为PTR4000。-This procedure for single-chip programming, the main function of wireless transceivers used for wireless chips PTR4000.

profibus 的官方文件，朋友给的，朋友可是花钱买来的。-PROFIBUS_DP SPECIFICATION

计算机简单控制由软件和硬件组成。软件由Visual Basic 6.0编写。硬件主要由无线发送模块和单片机（C语言编写）构成。通过RS232界面与PC通信而实现无线控制系统。 主要功能是：通过遥控器连接PC机的"上下左右"按键 ,当电脑界面处于powerpoint界面下,能通过遥控器控制幻灯片的上下切换. -Simple control by the computer software and hardware components. Software prepared by the Visual Basic 6.0. Hardware mainly by the wireless sending module and single chip (C language) constitute. Through the RS232 communication interface with the PC wireless control system. Main function is to: Connect PC through a remote control machine up and down about button, when the computer interface in a powerpoint interface via remote control to switch slides up and down.

利用单片机做的编码器输出值LED显示程序，用MAX7219驱动七段数码管，完成二‘十’十六进制的切换显示。-Does the use of single-chip encoder output LED display program with Seven-Segment LED Driver MAX7219, completion of the second